C8051F700-DK C8051F700 DEVELOPMENT KIT USERS GUIDE 1. Relevant Devices The C8051F700 Development Kit is intended as a development platform for the microcontrollers in the C8051F70x/71x MCU family. The members of this MCU family are: C8051F700, C8051F701, C8051F702, C8051F703, C8051F704, C8051F705, C8051F706, C8051F707, C8051F708, C8051F709, C8051F710, C8051F711, C8051F712, C8051F713, C8051F714, C8051F715. The target board included in this kit is provided with a pre-soldered C8051F700 MCU. Code developed on the C8051F700 can be easily ported to the other members of this MCU family. Refer to the C8051F70x data sheet for the differences between the members of this MCU family. 2. Kit Contents The C8051F700 Development Kit contains the following items: C8051F700 Target Board C8051Fxxx Development Kit Quick-Start Guide Silicon Laboratories IDE and Product Information CD-ROM. CD content includes: Silicon Laboratories Integrated Development Environment (IDE) Evaluation assembler, compiler and linker tools Source code examples and register definition files Documentation AC to DC universal power adapter USB debug adapter 2 USB cables 3. Hardware Setup Refer to Figure 1 for a diagram of the hardware configuration. 1. Connect the USB Debug Adapter to the DEBUG connector on the target board with the 10-pin ribbon cable. 2. Connect one end of the USB cable to the USB connector on the USB Debug Adapter. 3. Verify that shorting blocks are installed on the target board as shown in Figure 1. 4. Connect the other end of the USB cable to a USB Port on the PC. 5. Connect the ac/dc power adapter to power jack P2 on the target board. Notes: Use the Reset icon in the IDE to reset the target when connected during a debug session. Remove power from the target board and the USB Debug Adapter before connecting or disconnecting the ribbon cable from the target board. Connecting or disconnecting the cable when the devices have power can damage the device and/or the USB Debug Adapter. Rev. 0.3 8/13 Copyright 2013 by Silicon Laboratories C8051F700-DK Not Recommended for New DesignsC8051F700-DK USB Cable DS1 P4 P1 R8 (To PC) J16 DS3 J8 SWITCH P2.2 SWITCH P2.3 RESET P1.1 SW2 SW1 J12 VDD SWITCH P2.0 SWITCH P2.1 DEBUG DS2 J17 J1 J2 J15 P3 U1 J0 F700 J11 P2 USB Debug Adapter J3 J6 AC to DC Adapter SILICON LABS J5 J4 J7 C8051F700-TB TB1 www.silabs.com Figure 1. Hardware Setup using a USB Debug Adapter 2 Rev. 0.3 Not Recommended for New Designs J14 J13 J9 J10 POWER Silicon Laboratories USB DEBUG ADAPTER Run Stop Power