C6713 DSP STARTER KIT

DSP Starter Kit (DSK) for the TM S320C6713 (16 Mb) Quick Start Installation Guide Kit Contents +5V Universal AC Power Power Supply C6713 DSK Board Cord C6713 DSK Code Composer TMS320C6713 DSK USB Cable Studio CD ROM Technical Reference System Requirements Description 500MB of free hard disk space The 6713 DSP Starter Kit (DSK) is an all-in-one evaluation platform for the TMS320C6713 Digital Signal Processor Microsoft Windows 2000/XP from Texas Instruments. It includes a target board that 128MB of RAM can be used as a reference design for interfacing the DSP 16-bit color display to common devices such as SDRAM, Flash and a codec CD-ROM Drive as well as a special introductory version of TI s flagship Code Composer Studio development tools. An on-board Service and Support JTAG emulator allows debug from Code Composer Studio through your PC s USB port. Web Install DSK Content from the CD-ROM Connect the DSK to Your PC Before you install the DSK software, please make sure 1. Connect the supplied USB cable to your PC or laptop. you are using Administrator priviliges and any virus We recommend that anyone making hardware checking software is turned off. The DSK board should modifications connect through a USB hub for safety. not be plugged in at this point. 2. If you plan to install a microphone, speaker, or 1. Insert the Code Composer Studio installation CD into expansion card these must be plugged in properly the CD-ROM Drive. An install menu (see below) before you connect power to the DSK board. should appear. If it does not, manually run Launch.exe from the CD-ROM. Select the Install 3. Connect the included 5V power adapter brick to your Products option from the menu. AC power source using the AC power cord. 4. Apply power to the DSK by connecting the power brick to the 5V input on the DSK. 5. When power is applied to the board the Power On Self Test (POST) will run. LEDs 0-3 will flash. When the POST is complete all LEDs blink on and off then stay on. At this point your DSK is functional and you can now finish the USB driver install. USB connector (Plugs into USB Hub, or port on PC/Laptop) 2. Install any components you need. To debug with the DSK you must have 1) a copy of Code Composer Studio, 2) the target content package for your board USB Cable and 3) a copy of the FlashBurn plug-in. ON USB connector (Plugs into DSK) Users of the full Code Composer Studio package can 4 1 2 3 skip the DSK Code Composer installation and simply SW3 Jumpers install the target content packages. Power supply S1 1 2 0 3 0 1 2 3 LEDs Switches 6. Make sure your DSK CD-ROM is installed in your CD- ROM drive. Now connect the DSK to your PC using the included USB. After few seconds Windows will launch itsAdd New Hardware Wizar and prompt for the location of the DSK drivers. 7. Follow the instructions on the screens and let Windows find the USB driver files sdusbemu.inf and sdusbemu.sys on the DSK CD-ROM. On XP 3. The installation procedure will create two icons on systems Windows will find the drivers automatically. your desktop: 6713 DSK CCStudio 3 6713 DSK Diagnostics 506736-4001E Page 2 of 4 12502 Exchange Dr., Ste 440, Stafford, TX. 77477 T:281.494.4505, F:281.494.5310 www.spectrumdigital.com