EVAL-L9907-H STMicroelectronics

EVAL-L9907-H Data brief EVAL-L9907-H Evaluation Board Features Supply voltage range (VBatt): 6 V54 V Load Current Capability up to 120 A Device control and diagnostic via SPI Flexible shunt configuration (Phase U+PhaseV or PhaseU+Total Phase) 4 LEDs for monitoring VBatt, Vcc, EN1 and EN2 signal Input signal connector compatible with SPC56 Discovery boards. A different microcontroller board can be connected by a simple adaptor or wire Total accessibility to all pins by test points Modular PCBs design to easily change the external Power MOS both SMD and throughhole Power MOS Possibility to connect external USB adapter for the SPI communication Possibility to use external Boost components by removing jumpers Description The EVAL-L9907-H is designed to provide the user with a platform for the evaluation of the L9907 device. The Board provides all the main input/output capabilities necessary to drive a BLCD motor and provide also diagnostic functionalities. L9907 is fully integrated 3-phase pre-driver with integrated booster capable to drive all kind of Power MOS transistors in 3-phase BLDC motor applications up to 54 V. The integrated boost regulator provides sufficient gate charge to driver Power MOS down to 6 V. The circuit is suitable to operate in environments with high supply voltage Product status link such as double battery in 48V systems.L9907 is able to control independently the six pre-driver channels to implement all kind of electric motor control strategies, with the EVAL-L9907-H possibility to select among 4 gate output current levels while the application is running. All output channels are protected against short circuit.L9907 is equipped Order code References with 2 current sense amplifiers. The gain and output offset voltage of each current EVAL- EVAL-L9907-H Evaluation sense amplifier can be configured by SPI to allow max flexibility for phase or ground L9907-H board current sense strategy. L9907 is protected against over-temperature and shoot through events.The EVAL-L9907-H can be plugged directly to SPC560P-DISP Discovery+ board and using the L9907 demonstration software it is possible to implement a 3 phase brushless motors control. DB2384 - Rev 3 - April 2019 www.st.com For further information contact your local STMicroelectronics sales office.EVAL-L9907-H System requirements, HW and SW resources 1 System requirements, HW and SW resources 1.1 System requirements Power Supply: 6 V 54 V up to 120 A SPC560P-DISP discovery board or microcontroller board able to offer SPI signals, manage 2 EN and 6 PWM signals, 2 ADC inputs for current sensing and +5 V or 3,3 V (Vcc) 1.2 Development tool chain Graphic User Interface: Labview Software development environment (in connection with SPC5 MCUs): SPC5Studio Hardware set-up: Board stand alone Figure 1 PC Graphic User Interface -SPC560P-DISP (dedicated Firmware) - EVAL-L9907-H Figure 2 Any SPC56 Discovery + Application Examples (within SPC5 Studio) + EVAL-L9907-H Figure 3 Figure 1. EVAL-L9907-H evaluation board DB2384 - Rev 3 page 2/6