P-NUCLEO-USB001 STMicroelectronics

P-NUCLEO-USB001 STM32 Nucleo pack for USB Type-C and Power Delivery Data brief Features Two DRP USB Type-C receptacles USB 2.0 FS data communication interface as peripheral V load and discharge switches BUS V switches CONN Voltage and current sensing for V BUS monitoring EMI filters A power connector to interface with external power supply (not supplied) Description The STM32 Nucleo pack for USB Type-C and Power Delivery (P-NUCLEO-USB001) is a development tool for learning and developing solutions based on USB Type-C and USB Power Delivery technologies. This tool, in association with the certified 1. Picture is not contractual. embedded software solution (X-CUBE-USB-PD), provides the means to control two USB Type-C ports using a single STM32F072 32-bit microcontroller, based on ARM Cortex -M0. The X-CUBE-USB-PD is compliant with the USB Type-C 1.2 and USB Power Delivery 2.0 specifications. A simple analog front-end PHY is used to interface the STM32F072 MCU with the Configuration Channels (CC lines) of the Type-C receptacles and to allow the communication over these lines using the Power Delivery communication protocol. The P-NUCLEO-USB001 is fully configurable and ready to support different configurations such as Provider, Consumer or DRP. X-CUBE-USB-PD is compliant with the USB Type-C 1.2 and the Power Delivery 2.0 specifications. February 2017 DocID029202 Rev 2 1/7 For further information contact your local STMicroelectronics sales office. www.st.comP-NUCLEO-USB001 system architecture P-NUCLEO-USB001 1 P-NUCLEO-USB001 system architecture The STM32 Nucleo pack for USB Type-C and Power Delivery is composed of two main blocks (see Figure 1: P-NUCLEO-USB001 system architecture): A control block: the NUCLEO-F072RB MCU board where the stack is running A USB Type-C interface: the MB1257 expansion board Note: A certified USB Type-C full-featured cable is provided inside the package. 2/7 DocID029202 Rev 2