STBC03 Datasheet Li-Ion linear battery charger with LDO and load switches Features Charges single-cell Li-Ion batteries with CC/CV algorithm and charge termination Fast charge current up to 650 mA adjustable by external resistor Pre-charge current from 1 mA Adjustable floating voltage up to 4.45 V Integrated low quiescent LDO regulator Automatic power path management Auto-recharge function Embedded protection circuit module (PCM) featuring battery overcharge, battery over-discharge and battery overcurrent protections Charging timeout Shipping mode feature allows battery low leakage when over-discharged Very low battery leakage in over-discharge and shutdown mode Charger enable input Charge/fault status output Battery voltage pin to allow external gauging Two 3 SPDT load switches Available in Flip Chip 30, 400 m pitch package Rugged 4 kV HBM, ESD protection on the most critical pins Maturity status link Applications STBC03 Smart watches and wearable devices Fitness and medical accessories Device summary Li-Ion and other Li-Poly battery rechargeable equipment Order code STBC03JR LDO 3.0 V Description Package 400 m pitch The STBC03 is a highly integrated power management, embedding a linear battery charger, a 150 mA LDO, 2 SPDT load switches, and a protection circuit module (PCM) to prevent the battery from being damaged under fault conditions. The STBC03 uses a CC/CV algorithm to charge the battery the fast charge and the pre-charge current can be both independently programmed using dedicated resistors. The termination current is set to 5% of the programmed fast charge current, but has fixed values for fast charge currents lower than 20 mA. The battery floating voltage value is programmable and can be set to a value up to 4.45 V. The STBC03 also features a charger enable input to stop the charging process anytime. The STBC03 is automatically powered off from the connected battery when the IN pin is not connected to a valid power source (battery mode). A battery under/overtemperature condition can be detected by using an external circuitry (NTC thermistor). DS11889 - Rev 5 - May 2020 www.st.com For further information contact your local STMicroelectronics sales office.STBC03 The STBC03 draws less than 10 nA from the connected battery in shipping mode conditions, so to maximize the battery life during shelf life of the final application. The device is available in the Flip Chip 30 package. DS11889 - Rev 5 page 2/32