STEVAL-ISA042V1 STMicroelectronics

ST1S03 1.5 A, 1.5 MHz adjustable, step-down switching regulator Datasheet - production data Description The ST1S03 is a step-down DC-DC converter optimized for powering a low voltage digital core in HDD applications and, generally, to replace the high current linear solution when the power DFN6D (3 x 3 mm) dissipation may cause a high heating of the application environment. It provides up to 1.5 A over an input voltage range of 3 V to 16 V. A high Features switching frequency (1.5 MHz) allows the use of tiny surface-mount components: as well as the Step-down current mode PWM (1.5 MHz) resistor divider to set the output voltage value, DC-DC converter only an inductor, a Schottky diode and two 2% DC output voltage tolerance capacitors are required. Besides, a low output ripple is guaranteed by the current mode PWM Internal soft-start for STARTUP current topology and by the use of low ESR SMD ceramic limitation and power on delay of 50 - 100 s capacitors. The device is thermal protected and Typical efficiency: > 70% over all operating current limited to prevent damages due to an conditions accidental short-circuit. The ST1S03 device is 1.5 A output current capability available in a DFN6D package. Not switching quiescent current: max 2.5 mA Table 1. Device summary over temperature range Order code Package Packaging Switch V : max. 350 mV at I = 750 mA DS SW ST1S03PUR DFN6D (3 x 3 mm) Tape and reel Uses tiny capacitors and inductors Available in DFN6D 3 x 3 mm package with exposed pad November 2014 DocID10992 Rev 7 1/16 This is information on a product in full production. www.st.comContents ST1S03 Contents 1 Diagram . 3 2 Pin configuration . 4 3 Maximum ratings 5 4 Electrical characteristics . 6 5 Application notes . 7 6 Typical application 8 7 Typical performance characteristics 9 8 Package information 12 9 Revision history . 15 2/16 DocID10992 Rev 7