VN5E050JTR-E STMicroelectronics

VN5E050J-E Single channel high side driver for automotive applications Features Max supply voltage V 41V CC Operating voltage range V 4.5 to 28V CC Max on-state resistance (per ch.) R 50 m ON Current limitation (typ) I 27A LIMH PowerSSO-12 (1) Off state supply current I 2 A S 1. Typical value with all loads connected. Application General All types of resistive, inductive and capacitive Inrush current active management by loads. power limitation Very low stand-by current Description 3.0V CMOS compatible inputs The VN5E050J-E is a single channel high-side Optimized electromagnetic emissions driver manufactured in the ST proprietary Very low electromagnetic susceptibility VIPower M0-5 technology and housed in the tiny In compliance with the 2002/95/EC PowerSSO-12 package. european directive The VN5E050J-E is designed to drive automotive Diagnostic functions grounded loads delivering protection, diagnostics Open Drain status output and easy 3V and 5V CMOS-compatible interface On-state open load detection with any microcontroller. Off-state open load detection The device integrates advanced protective Output short to V detection CC functions such as load current limitation, inrush Overload and short to ground (power and overload active management by power limitation) indication limitation, over-temperature shut-off with auto- Thermal shut-down indication restart and over-voltage active clamp. Protections A dedicated active low digital status pin is Undervoltage shut-down associated with every output channel in order to Overvoltage clamp provide Enhanced diagnostic functions including fast detection of overload and short-circuit to Load current limitation ground, over-temperature indication, short-circuit Self-limiting of fast thermal transients to V diagnosis and ON & OFF state open-load CC Protection against loss of ground and loss detection. of V CC The diagnostic feedback of the whole device can Over-temperature shut-down with be disabled by pulling the STAT DIS pin up, thus autorestart (thermal shut-down) allowing wired-ORing with other similar devices. (a) Reverse battery protected Electrostatic discharge protection a. See Application schematic. September 2013 Rev 3 1/34 www.st.com 34Contents VN5E050J-E Contents 1 Block diagram and pin configuration . 5 2 Electrical specifications 7 2.1 Absolute maximum ratings . 7 2.2 Thermal data . 8 2.3 Electrical characteristics . 9 2.4 Waveforms 15 2.5 Electrical characteristics curves 19 3 Application information . 22 3.1 GND protection network against reverse battery . 22 3.1.1 Solution 1: resistor in the ground line (RGND only) 22 3.1.2 Solution 2: diode (DGND) in the ground line . 23 3.2 Load dump protection 23 3.3 MCU I/Os protection . 23 3.4 Open load detection in Off state 24 3.5 Maximum demagnetization energy (VCC = 13.5V) . 25 4 Package and PCB thermal data . 26 4.1 PowerSSO-12 thermal data . 26 5 Package and packing information . 29 5.1 ECOPACK packages . 29 5.2 Package mechanical data 29 5.3 Packing information . 31 6 Order codes . 32 7 Revision history . 33 2/34