CPFE1000Fi Series Specification Model CPFE1000FI-12 CPFE1000FI-28 CPFE1000FI-48 Input Input Voltage range Vac 90 - 265 Input Frequency Hz 47 - 63 Input Current (110 / 220Vac) A 13.6 / 6.6 (Model dependent) Inrush Current (110 / 220Vac) A 23 / 46 peak Leakage Current (at 230Vac, 50Hz) uA <1.5 Power Factor - 0.95 typical (meets EN61000-3-2) Hold Up Time (typ) at 230Vac Input ms 20 25C and warmer Efficiency (Typical, 100% load, 110 / 220Vac) % 79 / 81 83 / 86 83 / 86 Conducted & Radiated EMI - Conducted: EN55032/EN55011 Class B, Radiated: Class A Immunity - See Immunity table Line Dip - Complies with SEMI F47 (200Vac line only) Safety Certifications and Markings - IEC/UL/CSA/EN62368-1, 60950-1, CE Mark and UKCA Mark Immunity Test Standard Test Level Criteria Notes 8 kV air discharge, ESD IEC 61000-4-2 B 4 kV contact discharge 10 V/m from 80-1000 MHz Radiated Susceptibility IEC 61000-4-3 A (80% AM at 1kHz) Power line pulses of 2kV Electrical Fast Transient Burst IEC 61000-4-4 B I/O line pulses of 1kV 2kV common mode, Surge IEC 61000-4-5 B 1kV differential mode See test report 10 Vrms, 150 kHz - 80 MHz Conducted Susceptibility IEC 61000-4-6 B 1 kHz 80% AM Inductive loop at 50 Hz, Magnetic fields IEC 61000-4-8 A to 1.0 amps (rms) per meter Voltage Dips and Input Interruptions IEC 61000-4-11 Voltage Dips of 30% and >95% Interruptions of >95%. B / C 1kV, 2kV common mode surges. Ring Wave IEC 61000-4-12 B 0.5kV, 1kV differential mode surges. Voltage Fluctuation EN 61000-4-14 Level 3 U=12% Un A Specification Model CPFE1000FI-12 CPFE1000FI-28 CPFE1000FI-48 Output Line Regulation mV 48 56 96 Load Regulation mV 48 56 96 Temperature Coefficient ppm/C 200 Ripple & Noise (20MHz BW) (2) % 1 (2 below 0C) Minimum Load A None Overcurrent Protection % 105 - 140 (Automatic Recovery) Overvoltage Protection % 125 - 145 (Automatic Recovery) Overtemperature Protection C Shuts down between 90 - 115 (Auto Recovery) Remote Sense - Yes, compensates up to 500mV cable drop Remote On/Off (Opto Isolated) - High = ON Power On Signal (ENA) - Open Collector (10mA sink current). Low (on) when output is present Auxiliary Supply - 10 - 14V, 20mA Parallel Operation - Yes, single wire Series Operation - Possible, see installation manual 2 CPFE1000Fi Series