DT62/80-D Series Specifications Model DT62-D DT80-D Input Input Voltage range Vac 90 - 264 Input Frequency Hz 47 - 63 Input Current (90Vac) A 2 Inrush Current at 230Vac (Cold Start) A <100 (25C ambient) <150 (25C ambient) Leakage Current (264Vac 60Hz) uA <700 Power Factor - Typically 0.9 at full load, 230VAC (Meets EN61000-3-2) No Load Power Consumption mW <150 Hold Up Time (typ) at 115Vac Input ms 10 20 Efficiency % >89% (>86.1% 5V, >87.6% 6-10V models) >89% (>88% 9V model) Conducted & Radiated EMI - EN55032-B, FCC Part 15 Class B Immunity - EN55024 Safety Agency Certifications - UL/cUL/EN/IEC62368-1, UL/cUL/EN/IEC60950-1, CE Mark (LVD, EMC and RoHS) Output Voltage Accuracy % 2 Output Voltage Adjustment - None Switching Frequency (Full Load) kHz 50 - 70 45 - 55 Total Regulation % 5 Ripple & Noise (1) - See Model Selector Table Temperature Coefficient %/C 0.05 Minimum Load - No minimum load required Overcurrent Protection % 170 (Auto-Recovery) 110 - 180 (Auto-Recovery) Overvoltage Protection - See Model Selector Table (Cycle input power to reset) Short Circuit Protection - Continous - Hiccup Mode (Auto Recovery) Parallel Operation - Not possible Environmental Operating Temperature C 0 to +60, de-rate linearly to 50% load from 50 to 60 0 to +60, de-rate linearly to 50% load from 40 to 60 Storage Temperature C -10 to +85 Humidity (non condensing) %RH 10 - 90 Cooling - Convection Altitude m 2,000 Withstand Voltage (For 1 minute) Vac Input to Ground 1,500, Input to Output 3,000 (Output is connected to Ground) IP Rating - IPX0 Vibration (non-operating) m/s 223.52 (10 - 55Hz: constant sweep 1 min X, Y, Z for 1 hour) 2 Shock m/s <196.1 (20G) Other Weight (Typ) g 400 440 Size (LxWxH) mm 132 x 69 x 40 Size (LxWxH) Inches 5.2 x 2.72 x 1.57 AC Input Connector - IEC 320-C14 (Accepts IEC 320-C13) DC Output Connector - Kycon KPPx-4P or equivalent Pins 1 & 2: -Vout, Pins 3 & 4: +Vout Cable Length & Thickness 1050mm 5 to 8V Models: UL2464 18 AWG 1050mm 9 to 18V Models: UL11353 14 AWG 19 to 48V Models: UL11353 14 AWG 24 to 48V Models: UL11353 16 AWG MTBF (MIL-HDBK), 100% load, 25C hrs 140,000 120,000 Warranty yrs 3 Notes See website for detailed specifications, test methods and installation manual (1) Ripple and noise is measured at 20MHz BW. Add 0.1uF ceramic capacitor and 10uF Electrolytic capacitor in parallel across the output 2 DT62/80-D Series