TDK- L amb d a EVS-RP SPECIFICATIONS A271-01-01 MODEL EVS-RP6020 ITEMS 1 Input Voltage Range VDC 7 - 60 2 Maximum Input Current A 20 3 Internal Loss (max) (*1) W 4 4 Voltage drop (max) (*1)(*2) mV 200 5 Reverse Current (max) (*3) uA 50 6 Parallel Operation (*4) - Possible (MAX. 2 units, No current balance) 7 Series Operation - - 8 Over Current protection - - 9 Over Voltage protection - - 10 Operating Temperature (*5) - -20 - +74C (-20 - +50C:100%, +60C:80%, +74C:50%) 11 Operating Humidity - 20 - 90%RH (No Condensing) 12 Storage Temperature - -40 - +85C 13 Storage Humidity - 10 - 90%RH (No Condensing) 14 Cooling - Convection Cooling 15 Withstand Voltage - Input, Output - FG : 500VAC (20mA) for 1min 16 Isolation Resistance - More than 100MW at 25C and 70%RH Input, Output to FG : 500VDC 17 Vibration - At no operating, 10 - 55Hz (Sweep for 1min) 2 19.6m/s Constant, X,Y,Z 1hour each. 2 18 Shock - Less than 196.1m/s 19 Safety - Approved by UL60950-1, CSA60950-1, EN60950-1 20 Weight (Typ) g 60 21 Size (W x H x D) mm 50 x 26 x 77.5 ( Refer to Outline Drawing ) *Read instruction manual carefully, before using the EVS-RP. =NOTES= *1. Ta=25C, maximum input current. *2. Differential voltage between the input and the output, when input current is flowing. *3. Reverse current is sink current flowing in EVS-RP from output circuit. Specification condition is Ta=25C, input voltage = 0VDC and applied output voltage = 60VDC. *4. Each current of each EVS-RP must be less than 20A. Parallel connection is acceptable up to 2 units maximum. *5. Output Derating - Derating at standard mounting. Refer to LOAD vs. AMBIENT TEMPERATURE (A271-01-02 ). - When forced air cooling, refer to forced air cooling specifications (A271-01-03 ). - Load (%) is percent of maximum input current, do not exceed its derating of maximum load. TDK- L amb d a EVS-RP OUTPUT DERATING A271-01-02 *COOLING : CONVECTION COOLING LOAD (%) Ta (C) MOUNTING A-E -20 - +50 100 74 50 LOAD vs. AMBIENT TEMPERATURE (CONVECTION COOLING) 120 100 80 60 50 x 26 x 77.5 ( Refer to Outline Drawing ) 40 MOUNTING A-E 20 0 74 -20 -10 0 10 20 30 40 50 60 70 80 Ta ( C) MOUNTING A MOUNTING B MOUNTING C MOUNTING D MOUNTING E DON T USE (STANDARD MOUNTING) TB1 TB1 TB1(INPUT) TB1 TB1 TB1 LOAD (%)