Instruction Sheet
408-32120
EYE Check* Terminal Alignment Aid
05 JUN 15 Rev C
1. INTRODUCTION
EYE Check terminal alignment aid is a tool used to help adjust the terminal front feed position in an applicator.
It consists of a software program, which supports both Microsoft Windows and Apple Mac OS X operating
systems, and a camera assembly designed to attach to TE Ocean, HDM, and HDI side-feed applicators, and
crimp quality monitor (CQM) II on a bench terminator. The applicators have a space behind the terminal
support for the camera.
Reasons for re-issue of this instruction sheet are provided in Section 6, REVISION SUMMARY.
2. SYSTEM MINIMUM REQUIREMENTS
2.1. Microsoft Operating System
Software
Windows XP Service Pack 2 or later, 32 bit
Windows Vista, 32 bit
Windows 7, 32 or 64 bit
Windows 8 is compatible, but not supported
Hardware
512 MB system memory
2.2. Apple Operating System
Software
Mac OS X 10.6 or newer
Hardware
Intel Core 2 Duo or higher data processor
512 MB system memory
at least one available USB 2.0 or 3.0 port
2.3. Data Processor
GHz or faster
at least one available USB 2.0 or 3.0 port
3. INSTALLATION
3.1. Software
Windows Software
Run the Setup-AppCam.exe program from the installation CD. Refer to Figure 1. If a different installation
folder is desired, select the folder to install the program to by clicking the Browse button. Click Install.
Mac OS X Software
1. Open the AppCam.dmg file on the CD.
2. Drag the AppCam.app icon to the Application folder as shown in Figure 1.
Microsoft, Windows, Windows XP, and Windows Vista are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries.
Apple, Mac, and OS X are trademarks of Apple Inc., registered in the U.S. and other countries.
Intel Core is a trademark of Intel Corporation in the U.S. and/or other countries.
2015 TE Connectivity family of companies PRODUCT INFORMATION 1-800-522-6752 This controlled document is subject to change.
1 of 7
All Rights Reserved For latest revision and Regional Customer Service,
*Trademark visit our website at www.te.com.
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
ORIGINAL INSTRUCTIONS 408-32120
Windows Software Mac OS X Software
Figure 1
3.2. Camera Assembly
When installed, the camera assembly is attached to the applicator housing and base plate behind the anvil or
terminal support. It is held in place with magnets.
1. Install the camera so that the lens faces the anvil of the applicator. It should be located so that the
front of the camera housing is in line with, and in contact with, the front surface of the applicator
housing. The camera housing should be sitting flat on the applicator baseplate as shown in Figure 2.
2. Plug the camera into a USB port on the computer. If it is unplugged from the computer, it will be
necessary to exit and restart the operating system software.
NOTE
The anvil might not be centered in the camera screen. This is a normal condition caused by the tolerance stack-ups and will
not affect the function of the EYE Check terminal alignment aid.
Camera Assembly Camera Assembly Installed on Applicator
Camera Housing in Line Camera Housing
with, and in Contact with, Sitting Flat on
Applicator Housing Applicator Baseplate
Figure 2
2 of 7
Rev C