55/1122 SPECIFICATION CONTROL DRAWING Date Revision TITLE TWO CONDUCTOR CABLE, SHIELDED, JACKETED, OUTER SPACE, 600 VOLT 12-8-06 F This specification sheet forms a part of the latest issue of Raychem Specification 55/. COMPONENT WIRES - 55/0112 SHIELD - SILVER-COATED COPPER JACKET - LOW OUTGASSING, RADIATION-CROSSLINKED, MODIFIED ETFE CABLE CONSTRUCTION DETAILS JACKET THICKNESS OUTSIDE DIAMETER MAXIMUM CONDUCTOR SHIELD PART NUMBER SIZE SIZE (inches) (inches) WEIGHT 1/ (lb/1000 ft) (AWG) (AWG) MINIMUM NOMINAL NOMINAL MAXIMUM 55/1122-28-* 28 38 .006 .008 .087 .092 6.3 55/1122-26-* 26 38 .006 .008 .097 .102 7.9 55/1122-24-* 24 38 .006 .008 .107 .112 9.8 55/1122-22-* 22 38 .006 .008 .119 .125 12.2 55/1122-20-* 20 38 .006 .008 .133 .140 16.2 55/1122-18-* 18 38 .006 .008 .153 .161 21.9 55/1122-16-* 16 38 .006 .008 .169 .177 26.6 55/1122-14-* 14 38 .006 .008 .203 .213 38.4 55/1122-12-* 12 38 .007 .009 .241 .253 55.1 CABLE RATINGS AND ADDITIONAL REQUIREMENTS VACUUM STABILITY: TEMPERATURE RATING: 200C Maximum continuous conductor temperature Total Mass Loss (TML), 1.00% (maximum) VOLTAGE RATING: 600 volts (rms) at sea level Volitale Condensable Material, 0.10% (maximum) CROSSLINK VERIFICATION: 300 3C for 1 hour VOLTAGE WITHSTAND TEST (Post Environmental): DIELECTRIC WITHSTAND: 1500 volts (rms), 60 Hz 1500 volts (rms), 60 Hz, 1 minute JACKET COLOR: White preferred JACKET ELONGATION: 50% (minimum) PART NUMBER: JACKET FLAWS: The in the part numbers above shall be replaced by Spark Test, 1000 volts (rms) color code designators with a slash separating the Impulse Dielectric Test, 6.0 kV (peak) component wire colors and a dash separating the component wire colors from the jacket color. RADIATION RESISTANCE: 500 megarads SHIELD COVERAGE: 85% (minimum) 1/ Example: AWG 24, black and white component wires white jacket: 55/1122-24-0/9-9 NOTE: Nominal values are for information only. Nominal values are not requirements. Users should evaluate the suitability of this product for their application. Specifications are subject to change without notice. Tyco Electronics also reserves the right to make changes in materials or processing, which do not affect compliance with any specification, without notification to Buyer. 1/ COLORS AND COLOR CODE DESIGNATORS SHALL BE IN ACCORDANCE WITH MIL-STD-681. HOWEVER, DUE TO LENGTH LIMITATIONS OF THE RAYCHEM PART NUMBER, AN ALTERNATIVE COLOR CODE MAY REPLACE MIL-STD-681 COLOR CODE DESIGNATORS. (EXAMPLE: 901/902... MAY BE REPLACED BY Axxx.) OTHER CODES AND SUFFIXES MAY BE ADDED TO THE PART NUMBER, AS NECESSARY, TO CAPTURE ANY ADDITIONAL REQUIREMENTS IMPOSED BY THE PURCHASE ORDER. R Wire & Cable DIMENSIONS ARE IN INCHES, AND UNLESS OTHERWISE DESIGNATED ARE NOMINAL. 501 Oakside Avenue Page 1 of 1 Redwood City, CA 94063-3800 THIS SPECIFICATION SHEET TAKES PRECEDENCE OVER DOCUMENTS REFERENCED HEREIN. Phone: 1-800-227-8816 REFERENCED DOCUMENTS SHALL BE OF THE ISSUE IN EFFECT ON DATE OF INVITATION FOR BID. Fax: 1-650-361-6297 2006 Tyco Electronics Corporation. All rights reserved.X-ON Electronics Largest Supplier of Electrical and Electronic Components Click to view similar products for Multi-Conductor Cables category: Click to view products by TE Connectivity manufacturer: Other Similar products are found below : 89182-010-1000 6000FE-877-1000 M27500-20SP2S23 6300FE-877-U1000 6309UE-877-1000 6502FE 8771000 6541PA-008-U1000 CV6807-000 CW9530-000 CX6543-000 CXA-0066-20-4-9CS2973 CXA-0078-16-1-9CS2405 CXA-0078-22-4-9CS2405 CXA-0078-24-4- 9CS2405 CXA-0140-16-6/9-9CS2405 CY0660-000 720451-000 752687-000 82841-877-5000 8348-060-500 83559-002-1000 83653-002- 5000 83659-002-1000 83709-002-1000 8404-060-500 8469 060100 8628-060-500 868361-001 8730-060-1000 8737-060-U1000 8747-060- 100 8747-060-1000 8769-060-1000 8775-060-500 877541-000 8780-060-1000 88444-002-1000 9159-060-500 939870-000 9423 060U500 9444 060U1000 9497 0001000 9515-060-1000 9520-060-1000 9524-060-1000 9546-060-500 9572-002-U500 9774-060-1000 1213F-D15- A1000 1213F-009-A1000