91019-3 TE Connectivity

Instruction Sheet Extraction Tool 91019-3 408-7276 for Type XII Contacts 23 JAN 12 Rev C Wire Lead Tool Tip Tip Male Contact Handle Housing Tip Offsets in Cavity Figure 1 Figure 3 1. INTRODUCTION 5. Remove the contact by pulling it out of the rear of cavity. This tool (see Figure 1) is used to extract Type XlI (male and female) Contacts from their housings. A list of the 3.2. Extraction of Female Contact contacts is shown in the table in Figure 2. 1. Insert the tool tips into the offsets in the cavity. See Read these instructions carefully before using the tool. Figure 4 . 2. Push the tool into the housing until it bottoms in the CONTACT NUMBER cavity. FEMALE CONTACT MALE CONTACT The rear section of the handle will back out of the NOTE 66261 (66255 LP) tool. 66258 66262 (66256 LP) i (66252 LP) 66329 (66330 LP) 3. Keeping the tool bottomed in the cavity, push the 66259 (66253 LP) rear section of thehandle toward thehousing. 66257 66260 (66254 LP) 4. Remove the contact by pulling it out of rear of the 66251 LP) cavity. 66326 (66327 LP) Figure 2 Wire Lead 2. DESCRITION The tool consists of a sectionalized handle (see Cavity Figure 1) and two tooling tips. 3. EXTRACTION Housing 3.1. Exraction of Male Contact Tool Tips 1. Pull the rear section of handle back. 2. Keeping sections of handle separated, slide tool tips Figure 4 over male contact and into offsets in cavity. See Figure 3. 4. REVISION SUMMARY 3. Push the tips of the tool into the housing until they Revisions to this instruction sheet include: bottom in the cavity. Changed company name and logo 4. Keeping the tool bottomed in the cavity, push the Revised title error rear section of the handle toward the housing. 2012 Tyco Electronics Corporation, a TE Connectivity Ltd. Company TOOLING ASSISTANCE CENTER 1-800-722-1111 This controlled document is subject to change. 1 of 1 All Rights Reserved PRODUCT INFORMATION 1-800-522-6752 For latest revision and Regional Customer Service, *Trademark visit our website at www.te.com LOC B TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners. X-ON Electronics Largest Supplier of Electrical and Electronic Components Click to view similar products for Extraction, Removal & Insertion Tools category: Click to view products by TE Connectivity manufacturer: Other Similar products are found below : M8196914-08 768211-2 809-131 844751-2 8-59558-2 91018-1 12014013 12093647 1-21048-0 R282867020 12093078 1-21048-6 12121897 DCF.91.405.5LT 1322 15314260 15313892 15350698 15350707 15430130 1579018-4 1643916-1 1-679532-0 1976593-3 OUTEXT-0321 2-1579008-3 2-1579008-4 229694-7 231106-1 241469 91040-3 91040-7 965004-000 965069-000 1738219-1 ET-JL05-16 FG 0300 146 3000 FIT-6 210S048 2-1579007-9 231879-1 312138-3 RJ11FODE 356-162 M8196914-10 4-1579018-0 430395-001 483249- 1 5-1579007-2 5-1579007-9