PPE6KV Teledyne

CLEANING 10000 Impulse HIGH VOLTAGE The exterior of the probe only should be cleaned with a soft cloth moistened with 1000 either water or isopropyl alcohol. DC + peak AC PPE 6 kV 100 USING AND MAINTENANCE 10 The probe user should note that the protection 0,1 1 10 100 1000 provided by the equipment may be impaired, Frequency MHz if the equipment is used in a manner not specified by the manufacturer. To guarantee accurate performance SAFETY INFORMATION characteristics, machanical shocks should be The probe is designed to be safe under the avoided, as well as damage to the cable following conditions: through excessive bending. Handle with care, Indoor use especially when the extra thin spring-tip is Altitude to 2000 m fitted. All maintenance should be referred to Temperature range from 0 C to 50 C qualified personnel. Maximum relative humidity 80 % for tem- peratures up to 31 C, decreasing linearly to 40 % relative humidity at 50 C ELECTRICAL CHARACTERISTICS GENERAL CHARACTERISTICS SALES & SERVICE LECROY System attenuation: 1000:1 Operating temperature: 0 C to 50 C WARNING Corporate Headquarters System input resistance: 50 M Cable length: 2 m Input capacitance: < 6 pF Weight of probe + accessories: 70 gr U.S.A.: Chestnut Ridge Do not disassemble or disconnect probes while Compensation range: 10 pF to 50 pF Coupling: 1 M DC/AC Phone (1) 914 578 6020 they are connected to a voltage source. Use only Fax (1) 914 578 5985 System BW (-3 dB): 400 MHz typical Warranty: One year grounded oscilloscopes. Max. non-destructive input voltage: 6 kV Overvoltage category: CAT I European Headquarters See voltage derating curve Pollution degree: 1 Attention: Refer to this manual before Germany: Heidelberg using the probe. Phone (49) 6221 827 00 Fax (49) 6221 834 655 Danger. High Voltage. Voltage V LF PROBE ADJUSTMENT (1000:1) HF PROBE ADJUSTMENT 11 Connect the probe to a 1 kHz square wave The probe can be adjusted for high frequency if 10 2 signal. Adjust compensation trimmer in the necessary. Remove boot and isolation from 1 BNC-box for optimum square wave response. BNC-box. Connect the probe to 1 MHz square 5 wave signal. Turn the PCB in the BNC-box by 180 7 6 8 9 and adjust this trimmer for optimum square wave 3 response. Then replace all parts again in their 4 previous position. STANDARD ACCESSORIES SUPPLIED OPTIONAL PROBE KIT PK103 Undershoot WITH THE PROBE Same as standard accessories supplied with probe, except for: Accessories Quantities Straight tip (5 pieces) Undershoot 1. Trimming tool 1 Spring contact tip (5 pieces) 2. Sprung hook 1 3. IC Insulating tip (red) 1 4. Insulating tip (red) 1 5. Ground lead (22 cm) 1 Correct 6. BNC Adapter 1 7. Straight tip (0.8 mm) 1 8. Spring contact tip (0.8 mm) 1 9. Crocodile clip 1 Correct 10. Flexible 4 mm security adapter 1 11. Security ground lead 1 The following accessories are rated up to: Sprung hook 1000 V Overshoot BNC Adapter 100 V Crocodile clip 1000 V Flexible 4 mm security adapter 1000 V Overshoot