TPD1030F Toshiba Intelligent Power Device Silicon Monolithic Power MOS Integrated Circuit TPD1030F 2-IN-1 Low-Side Switch for Motor, Solenoid and Lamp Drive The TPD1030F is a 2-IN-1 low-side switch. The IC has a vertical MOSFET output which can be directly driven from a CMOS or TTL logic circuit (e.g., an MPU). The IC is equipped with intelligent self-protection functions. Features Two built-in power IC chips with a new structure combining a 2 control block and a vertical power MOSFET (L --MOS) on each chip. Weight: 0.08 g (typ.) Can directly drive a power load from a CMOS or TTL logic. Built-in protection circuits against overvoltage (active clamp), overtemperature (thermal shutdown), and overcurrent (current limiter). Low Drain-Source ON-resistance: R = 0.6 (max) ( V = 5 V, I = 0.5 A, T = 25C) DS (ON) IN D ch Low Leakage Current: I = 10 A (max) ( V = 0 V, V = 30 V, T = 25C) DSS IN DS ch Low Input Current: I = 350 A (max) ( V = 5 V, T = 40 to 110C) IN IN ch 8-pin SOP package with embossed-tape packing. Pin Assignment (top view) Marking SOURCE1 1 8 DRAIN1 TPD1030 Part No. (or abbreviation code) F Lot No. IN1 2 7 DRAIN1 Note SOURCE2 3 6 DRAIN2 Note : A line under a Lot No. identifies the indication of product Labels IN2 4 5 DRAIN2 G /RoHS COMPATIBLE or G /RoHS Pb Please contact your TOSHIBA sales representative for details as to environmental matters such as the RoHS compatibility of Product. The RoHS is Directive 2011/65/EU of the European Parliament and of the Council of 8 June 2011 on the restriction of the use of certain hazardous substances in electrical and electronic equipment. Note: Due to its MOS structure, this product is sensitive to static electricity. Start of commercial production 1999-10 1 2013-11-01 TPD1030F Block Diagram SOURCE1 1 8 DRAIN1 Overtemperature Detection Overcurrent Detection /Protection /Protection IN1 2 7 DRAIN1 SOURCE2 3 6 DRAIN2 Overtemperature Detection Overcurrent Detection /Protection /Protection IN2 4 5 DRAIN2 Pin Description Pin No. Symbol Pin Description 1 SOURCE1 Source pin 1 Input pin 1 2 IN1 This pin is connected to a pull-down resistor internally, so that even when input wiring is open-circuited, output can never be turned on inadvertently. 3 SOURCE2 Source pin 2 Input pin 2 4 IN2 This pin is connected to a pull-down resistor internally, so that even when input wiring is open-circuited, output can never be turned on inadvertently. Drain pin 2 5, 6 DRAIN2 Drain current is limited (by current limiter) if it exceeds 0.7 A (min) in order to protect the IC. Drain pin 1 7, 8 DRAIN1 Drain current is limited (by current limiter) if it exceeds 0.7 A (min) in order to protect the IC. 2 2013-11-01