OPB739RWZ TT Electronics

Focused for maximum sensitivity Phototransistor Output 650nm Visible Red LED to optimize detection of dye based inks Low-cost plastic housing 24 minimum 26AWG wire leads Optimal operating distance range 0.015 .38mm to 0.045 1.14mm The OPB739RWZ is a reflective line reader sensor. The sensor utilizes a visible red (650nm) LED and an NPN silicon phototransistor mounted side by side on converging optical axes in a black plastic housing. The converging light beam makes this sensor capable of detecting line widths as small as 0.004 0.1mm at the optimum distance of 0.030 0.76mm from the target. The red LED maximizes the reflected signal contrast of black lines on white backgrounds. Recommended line spacing is .050 minimum. This sensor can be used with Opteks OCB100CZ auto calibration module to reduce variability from sensor to sensor and to achieve a digital output. Custom electrical, wire, cabling and connectors are available. Contact your local representative or OPTEK for more information . Line Reading Low Resolution Bar Code Sensing Paper edge detection Mark detection Reflective Optical Encoders Ro HS Storage and Operating Temperature Range -40 C to +85 C Input LED Forward DC Current 40 mA Reverse DC Voltage 2 V Power Dissipation 100 mW Output Phototransistor Collector-Emitter Voltage 30 V Emitter -Collector Voltage 5 V Power Dissipation 100 mW Input IR LED V Forward Voltage 1.2 2.0 2.3 V I = 20 mA F F I Reverse Current - - 100 A V = 2 V R R Peak Emission Wavelength - 650 - nm I = 20mA P F Output Phototransistor V Collector Emitter Breakdown Voltage 30 - - V I = 100 A (BR)CE0 C V Emitter Collector Breakdown Voltage 5 - - v I = 100 A (BR)ECO E I Collector Dark Current - - 100 nA V = 10 V, I = 0 CEO CE F (3) Tr Rise Time - 300 - s V = 5 Volts CE I = 1 mA C Tf Fall Time - 300 - s R = 20K L Coupled Characteristics (1)(2) d = 0.030 (.76 mm) I On-State Collector Current 0.25 - - mA C(ON) I = 20 mA, V = 5 V F CE (1)(2) d = 0.030 (.76 mm) V Collector Emitter Saturation Voltage - - 0.4 V CE(SAT) I = 50 A, I = 20 mA C F I = 20 mA, V = 5 V F CE I Crosstalk Collector Current - - 0.05 mA CX No reflective test surface present Notes: 1. d is the distance from the assemblys lens surface to the reflective surface. 2. Measured using 90% diffuse reflectance white test card as the reflecting surface. 3. Typical values by design. Rise and Fall times are not tested. 4. Methanol or Isopropanol are recommended as cleaning agents. Plastic housing is soluble in chlorinated hydrocarbons and keton es.