Choice of four output options in low -cost side-looking package Choice of two sensitivity options (OPL560/561/562/563) High noise immunity Direct TTL/LSTTL CMOS interface Data rates to 250 kBaud for all except OPL560 series (200 kBaud) Low power consumption All components in this series include a photodiode, amplifier, voltage regulator, Schmitt trigger and NPN output transistor on a single silicon chip. OPL560 chips also include a voltage regulator on the chip. All devices in the series have a Photologic chip that is encapsulated in a molded plastic side-looking package with an integral lens (recessed integral lens for OPL535 and OPL536). This packaging provides enhanced optical coupling, combined with mechanical protection. The hysteresis characteristics of the Schmitt trigger on each device offers high immunity to noise on input and V . CC OPL530, OPL531, OPL535 and OPL536 include a 10 K pull-up resistor (R ) from output to V . These L CC components exhibit very stable performance over supply voltages ranging from 4.5 V to 16 V and a wide range of irradiance levels. OPL550 and OPL551 devices feature TTL/LSTTL compatible logic level output which can drive up to 8 TTL loads without additional circuitry and medium-speed data rates to 250 kBaud, with typical rise and fall times of 25 nanoseconds. OPL560, OPL561, OPL562 and OPL563 devices feature TTL/LSTTL compatible logic level output which can drive up to 10 TTL loads over supply voltages ranging from 4.5 V to 16 V. OPL530, OPL531, OPL550, OPL551, OPL560, OPL561, OPL562 and OPL563 are mechanically and spectrally matched to OP140 and OP240 LEDs. OPL535 and OPL536 are mechanically and spectrally matched to OP145 and OP245 series LEDs. Input Power Range 2 (mW/cm ) Min/Max Base Part Number Package Output Type - with Light Non-contact reflective - A B object sensor OPL530 Internal 10K - High External Assembly line automation Lens OPL531 Internal 10K - Low Machine automation 0.08/0.40 0.08/0.25 0.20/0.40 Machine safety OPL535 Internal 10K - High Recessed End of travel sensor Lens OPL536 Internal 10K - Low Door sensor OPL550 Totem Pole - High 0.25/2.4 0.25/1.4 N/A OPL551 Totem Pole - Low 0.25/2.5 0.25/1.5 OPL560 Totem Pole - High External 0.09/0.55 0.09/0.36 0.18/0.55 Lens OPL561 Totem Pole - Low OPL562 Totem Pole - High 0.025/0.23 0.025/0.14 0.07/0.23 OPL563 Totem Pole - Low OC = Open Collector Output Ro HS OPL530, OPL550, OPL560 Series MILLIMETERS DIMENSIONS ARE IN: INCHES Pin Sensor 1 Ground Pin Sensor 2 Output 1 Ground 3 V CC 2 Output 3 Vcc OPL535, OPL536 Series MILLIMETERS DIMENSIONS ARE IN: INCHES Pin Sensor Pin Sensor 1 Ground 1 Ground 2 Output 3 V CC 2 Output 3 Vcc