Rotating links Mounting holes Setup Instructions - JS-SRR100 On stage, behind the board, or in the studio, sometimes you need your rack to roll with you. The Rolling Rack Stand easily accommo- dates, boasting an 11U-over-8U rack on casters, two of which lock to keep your rack from rolling away. The top section is angle- adjustable for convenience, and the frame is built from rugged steel for durability. SETUP INSTRUCTIONS JS-SRR100 : PARTS INCLUDED ( ) A. 3 Cross bars ( ) A. B. 2 Side angle bars with wheels ( ) C. 1 Top rock ( ) D. 1 Allen wrench (Tool) ( ) E. 2 Tightening knobs C. B. E. ( ) F. F. 6 Large screws H. G. D. G. (6) Washers - H. Bag of small screws & mounting clips STEP 1. STEP 2. STEP 3. 1. Using large screws, washers, and allen wrench 2. Line up all three cross bars with other side and 3. Attach top rack to assembled rack by lining up attach all three cross bars to one of the side hand tighten large screws with washers. After rotating links over each other. Start with one angle bars with wheels. Make sure mounting all three bars have been attached use an allen side and snap the other into place. holes are on the inside. wrench to finish tightening. STEP 4. STEP 5. 4. Screw in tightening knobs to both sides. These 5. Use a flat head screw driver too attach are used to adjust top rack to desired angle. mounting brackets. Use small screws to attach equipment to mounting brackets. R. 1, 08/31/10, JAM-HT JS-SRR100 5836 Wright Drive Loveland, CO 80538 Phone. 1-800-525-5628 Fax. 970.776.1941 Web. www.ultimatesupport.com X-ON Electronics Largest Supplier of Electrical and Electronic Components Click to view similar products for ultimate support manufacturer: Other Similar products are found below : HYP-1010 JS-SRR100 BMB-200K TS-90B