LA9P6 3662-5 4.5 LONG CARD WIRING SIDE CAUTION: In any plug contact area on either side of Plugbord, use only those holes having pads. Holes without pads may have insufficient clearance to ad- jacent circuitry, and using them could cause shorting. X, Y, Z = Horizontal Position DIPs 3. Before pressing terminals into board, position (rotate) terminals to A, B, C = Vertical Zone Position DIPs maximize the clearance between the widest part of the terminal and the nearest adjacent conductor. 2. Intended for use in non-hostile environments up to 200 volts RMS or 300 volts DC. 1. Broken circles above edge contacts indicate location of actual con- nector contact pads on opposite side of board. Zone letters, A, B, C, etc. on Y axis and X, Y, Z on X axis mark position for 14- or 16-pin DIPs NOTES: VECTOR DIP PLUGBORD TM PATTERN 0.042 X 0.1 SPACED HOLES LA9P6 LAYOUT PAPER NOTICE Where tin coated circuitry exists a small percentage of the holes may have solder blockage. This is usually a light skin easily penetrated by component leads. In some cases, a soldering iron may be required.LA9P7 3662-5 4.5 LONG CARD COMPONENT SIDE 5. In any plug contact area on either side of Plugbord, use only those holes having pads. Holes without pads may have insufficient clearance to adjacent circuitry and using them could cause shorting. 4. Before pressing terminals into board, position (rotate) terminals to X, Y, Z = Horizontal Position DIPs maximize the clearance between the widest part of the terminal and the A, B, C = Vertical Zone Position DIPs nearest adjacent conductor. 2. Intended for use in non-hostile environments up to 200 volts RMS or 300 volts DC. 1. Broken circles above edge contacts indicate location of actual con- Zone letters, A, B, C, etc. on Y axis and X, Y, nector contact pads on opposite side of board. Z on X axis mark position for 14- or 16-pin DIPs NOTES: VECTOR DIP PLUGBORD TM PATTERN 0.042 X 0.10 SPACED HOLES LA9-P7 LAYOUT PAPER ISSUE 86-4