Ground cord used to connect mats to (Earth Bonding Point) plugs 6 1 megohm (1x10 ohms) resistor in socket end 2.5mm cord diameter PVC insulation with 7 ends duplex tinsel copper conductor Both ends terminated with a 10mm female snap socket Item Description VER-26971 CORD,STRAIGHT,2.5M,10MMSOCKET/ 10MM SOCKET EPA ground cords shall be used to make electrical connections between groundable points and the EPA ground facility. Where a single resistor is used in the EPA ground cord, this shall be located near the groundable point. Where more than one resistor is used, a resistor of a minimum resistance value of one half the total resistance shall be located near the groundable point. When accessible, the EPA ground cord and its groundable point connection shall be Made in the Unless otherwise noted, tolerance is 10% shrouded by insulating material. (EN 61340-5-1 section 5.3.4 EPA ground cords) United Kingdom Specifications and procedures subject to change without notice. Straight Cord, 10mm Socket, 10mm Socket VERMASON DATE: UNIT C, 4TH DIMENSION, FOURTH AVENUE, LETCHWORTH, Drawing Number HERTS, SG6 2TD UK September PHONE: +44 (0) 1462-672005, FAX: +44 (0) 1462-670440 VER-26971 2015 E-MAIL:Service Vermason.co.uk, INTERNET: Vermason.co.uk 2015 VERMASON.X-ON Electronics Largest Supplier of Electrical and Electronic Components Click to view similar products for vermason manufacturer: Other Similar products are found below : 203015 237670 230260 238711 35594 230660 072425B 50424 242296 229775 J6609 VER-29082 47200 231725 231250 242270 47201 230480 203065 237200 229100 249205 230310 229795 230647 230370 231275 237675 231280 35267 242278 231345 35595 229135 230646 VER-26457 230420 35592 35622 241030 241100 ASBB4