R E l AYS A N D C O N TA C TO R S
D.C. Power Contactors Type 0
Type 120
coil contact Rating-(Amps.) DImens Ions
sTAnco R coil Resistance Inductive l oad Inches
P ART Duty Terminal Pole Bracket Volt. ( ohms) contact Volt. normally o pen normally c losed case Weight Agency
sec. nUmBeR cycle Type* Form style D. c. @ 25c m aterial D. c. continuous Inrush ** continuous Inrush l W h (oz.) certif.
A 120-901 Continuous 4 SPNO Standard 12 16.0 Silver Alloy 12 100 400 - - 2.13 2.88 3.25 6.0 -
120-907 Continuous 4 SPNO L 12 16.0 Silver Alloy 12 100 400 - - 2.50 3.00 3.25 6.0 -
120-943 Continuous 5 SPNO L 12 16.0 Silver Alloy 12 100 400 - - 2.50 3.00 3.25 6.0 -
120-913 Continuous 3 SPNO Standard 12 16.0 Silver Alloy 12 100 400 - - 2.13 2.88 3.25 6.0 -
B 120-906 Intermittent 4 SPNO Standard 12 6.0 Copper 12 80 400 - - 2.13 2.88 3.25 6.0 -
120-912 Intermittent 4 SPNO L 12 6.0 Copper 12 80 400 - - 2.50 3.00 3.25 6.0 -
120-902 Continuous 4 SPNO Standard 15 20.8 Silver Alloy 15 100 400 - - 2.13 2.88 3.25 6.0 -
120-908 Continuous 4 SPNO L 15 20.8 Silver Alloy 15 100 400 - - 2.50 3.00 3.25 6.0 -
120-903 Continuous 4 SPNO Standard 18 37.0 Silver Alloy 18 100 400 - - 2.13 2.88 3.25 6.0 -
C 120-904 Continuous 4 SPNO Standard 24 64.0 Silver Alloy 24 100 400 - - 2.13 2.88 3.25 6.0 -
120-910 Continuous 4 SPNO L 24 64.0 Silver Alloy 24 100 400 - - 2.50 3.00 3.25 6.0 -
120-905 Continuous 4 SPNO Standard 36 160.0 Silver Alloy 36 100 400 - - 2.13 2.88 3.25 6.0 -
120-911 Continuous 4 SPNO L 36 160.0 Silver Alloy 36 100 400 - - 2.50 3.00 3.25 6.0 -
D 120-914 Continuous 6 SPNO Standard 15 23.0 Silver Nickel 15 100 400 - - 2.13 2.87 3.09 6.0 -
120L-915 Continuous 7 SPNO L 12 6.0 Silver Alloy 12 80 400 - - 2.50 3.00 3.14 6.0 -
Water Resistant For outline drawings refer to page 53.
Intermittent Duty Cycle = 30 seconds on maximum and 6 minutes off
* Terminal Type: 4 = Isolated Coil, 6 = Isolated Coil Automotive, 7 = Latching Contacts
** Inrush Current: Current applied within the first 1/2 second of contact closure
Engineering Design Data
operation in % of n om. Breakdown Voltages
coil Rating coil Voltage Rating All Terminals - 60 h z Rms contact m aterial electrical l ife mechanical l ife
nominal open max.
magnetic max. contacts oper. oper. oper.
D. c. coil Rating safe opposite same To oper. At Per oper. At Per Temp.
Type (Watts) Pick-up operate Polarity Polarity Ground Power Pilot Rated l oad m in. no l oad m in F
120 - 75% 110% 500 500 500 Copper - 10,000 2 100,000 30 150
Silver Alloy 50,000 2 100,000 30
hardware Torque s pecification
Temperature Range
Intermittent Duty: -20F to 150F Contact Terminal: 45-55 inch-lbs.
Coil Terminal: 12-18 inch-lbs.
Continuous Duty: -20F to 120F
c aution: A back up wrench must be used to hold the bottom
Power (approximate)
nut stationary
Continuous 8.1 watts
Intermittent 14.4 watts
Terminations
Type 120 c ustom Design c apabilities
Contacts: 5/16" - 24 studs, UNF - 2A thread Coil Voltages 6VDC through 48VDC
Coil: #10-32, UNF - 2A thread
1/4" Contact Studs
1/4" Q.C. Coil Terminals
Recommended m ounting
U.L. 94-VO rated case material
Coil terminals up or horizontal
Please complete application data form on page 95 of this section
note: caution must be used in coil selection for use in 12 volt systems where battery charging may expose coil to continuous,
higher-than-rated voltage. s tancor will not be responsible for consequences of misapplied solenoids.
www.stancor.com
R E l AYS A N D C O N TA C TO R S
Type 0 & 0L
Terminal Type Grounded Coil to Bracket
L
H
2.125
1.062 3.253
Terminal Type Delphi Connection (STD Bracket)
2.125
1.062
2.125 3.094 MAX.
1.375
W
.312
2.875
#10-32 UNF-2A
2.875
THREAD
1.375
2.125
.281 WIDE X .400 LONG
.451
.250
(2 SLOTS)
.495
MIN.
MIN.
.048
.875
.281 WIDE X .400 LONG
.388
MIN.
5/16-24 UNF-2A THREAD
CIRCUIT
(2 PLACES)
DIAGRAM
.875
Terminal Type Isolated Coil (L Bracket)
H MAX.
L CIRCUIT
5/16-24 UNF-2A
2.50
3.25 DIAGRAM
.900 THREAD TYP.
2.125
Terminal Type Latching Coil (L Bracket)
W 3.00 1.375
.625
3.137
MAX.
LABEL
2.500
.900
WIDE .281 X
.400 LONG SLOT
#10-32 UNF-2A THD.
(2 PLACES)
5/16-24 UNF-21 THD. .625
.451
(2 PLACES)
2.125
MIN.
.495 MIN.
1.375
3.00
.875 .234
CIRCUIT .281 WIDE X .400 LONG
.048
1.344
DIAGRAM
(4 SLOTS)
1.750
Terminal Type
Grounded Coil with Q.C. Terminal
L 3.253 MAX.
4.000 .125
.900
2.500
.220 MIN.
#10-32 UNF-2A THREAD TYP.
3.00
.495 MIN.
1.375
5/16-24 UNF-2A
2.125
.312
THREAD TYP.
.875
1.344
.281 WIDE X .400 LONG
1.750 CIRCUIT
(4 SLOTS)
DIAGRAM
.032 X .250 QUICK CONNECT
.495 MIN.
.875
CIRCUIT
DIAGRAM
5/16-24 UNF-2A THREAD
(2 PLACES)
www.stancor.com
A