171010502 3 MagI C Power Module VDMM - Variable Step Down MicroModule 2.5V - 5.5V Input / 1A Output / 0.8V - 5.5V Output DESCRIPTION FEATURES 3 The VDMM 171010502 MagI C MicroModule Peak efficiency up to 96% provides a fully integrated DC-DC power supply Current capability up to 1A including the switching regulator IC with integrated Input voltage range: 2.5V to 5.5V MOSFETs, controller, compensation and shielded Output voltage range: 0.8V to 5.5V inductor in one package. 25A typical quiescent current Integrated shielded inductor The 171010502 offers high efficiency and delivers Low output voltage ripple: 6mV typ. up to 1A of output current. It operates with an input Output voltage accuracy over temperature: 2% max voltage from 2.5V to 5.5V and is designed for a Fixed switching frequency: 4MHz small solution size. Constant on-time control Synchronous operation The selectable forced COT or power save mode Selectable forced COT or power save mode allows for the choice between high efficiency and Undervoltage lockout low output voltage ripple at light load. Internal soft-start Thermal shutdown The 171010502 is available in an LGA-6EP Short-circuit protection package (3.2 x 2.5 x 1.55mm). Cycle-by-cycle current limit RoHS und REACh compliant This module has integrated protection circuitry Operating ambient temperature up to 85C that guards against thermal overstress with thermal Operating junction temp. range: -40C to 125C shutdown and protects against electrical damage Complies with EN55032 class B radiated emissions using overcurrent, short-circuit and undervoltage standard protections. TYPICAL APPLICATIONS General point of load power supply for low power systems Replacement of linear regulators DSP and FPGA power supply auxiliary voltages Portable instruments Battery powered equipment TYPICAL CIRCUIT DIAGRAM 4 1 Module V VIN VOUT V IN OUT 5 R C FBT FF EN 3 C C IN 2 FB OUT MODE R FBB PGND PGND EP 6 GND GND Data Sheet version 3.0 November 2021 www.we-online.com/powermodules 1171010502 3 MagI C Power Module VDMM - Variable Step Down MicroModule PINOUT SYMBOL NUMBER TYPE DESCRIPTION Output voltage. Place output capacitors as close as possible to VOUT VOUT 1 Power and PGND. For thermal performance, use copper plane(s) at this pin. Forced COT or power save mode selection pin. Settings this pin high, the forced COT mode is selected for every load current. Settings this MODE 2 Input pin low, power save is selected, with the transition automatically occurring between the two operationing modes according to the load. This pin must not be left floating. Feedback pin. This pin must be connected to the external resistor FB 3 Input divider (between VOUT and PGND) to adjust the output voltage. Input voltage. Place the input capacitor as close as possible to VIN VIN 4 Power and PGND. Enable pin. Setting this pin high enables the device, while setting this EN 5 Input pin low shuts down the device. This pin must not be left floating. Power ground. It must be connected to the ground plane and to the PGND 6 Power thermal pad. Exposed pad. This pin is internally electrically connected to PGND. It Exposed PGND EP is recommended to connect it to the ground plane for device heat Pad dissipation. Data Sheet version 3.0 November 2021 www.we-online.com/powermodules 2