XR1000/903 Advanced Energy

HITEK POWER XR1000 1 KW X-RAY POWER SUPPLY MODULE The HiTek Power XR1000 series is a component power supply for industrial x-ray systems, elemental analysis equipment, x-ray diffraction spectrometers, and materials process monitoring applications. It incorporates a floating filament supply that is automatically controlled by the integral beam loop. It is based on the proven HiTek Power IGBT converter, ensuring high efficiency and reliable operation. The XR1000 units are available with either an analog or RS-232 control interface. PRODUCT HIGHLIGHTS 1 kW of output power Extensive tube protection facilities Robust IGBT converter design Short-circuit and overload protection High stability High-accuracy BEAM CURRENT control Low ripple Analog or RS-232 interface CE Marked for EU LV Directive 2006/95/EC TYPICAL APPLICATIONS X-Ray Fluorescence (XRF) X-Ray Diffraction (XRD) X-Ray Reflectivity (XRR) X-Ray Imaging (XRI) 2018 Advanced Energy Industries, Inc.HITEK POWER XR1000 SERIES ELECTRICAL SPECIFICATIONS Output Power 1 kW, max, at full rated output voltage and current Output Voltage 0 to -60 kV or 0 to -90 kV Output Current 60 kV unit: 0 to 16 mA 90 kV unit: 0 to 11 mA Input Voltage 230 VAC 10% (207 to 253 VAC) 47 to 63 Hz, single phase and earth Input Current Not exceeding 12A rms Polarity Negative Specification Range Specifications apply above 5% of rated output voltage and current Ripple < 0.25% of setting plus 0.25% of rating, peak to peak Arc Count and Extinguish Each time the ACE system detects an arc, it blanks the supply off for a brief period to extinguish the arc. (ACE) The unit is then allowed to recover. If more arcs occur, they are counted to determine the arc rate if this exceeds a safe level, the power supply is shut down. The parameters are factory set. Metering Provided as part of an alphanumeric display Voltages are displayed with a resolution better than 0.5% of rated output. Current is displayed with a resolution of better than 1.5% of rated output Status Indication The alphanumeric display shows the status of the interlock and the reason for any trip condition. Voltage Regulation Line < 0.05% change in output voltage for a 10% change in line voltage Static Load < 0.05% change in output voltage for a 5 to 100% change in output current Dynamic Load < 5% change in output voltage for a 5 to 100% change in output current, recovery to within 1% of previous setting within 200 msec Beam Current Regulation Line < 0.05% change in output current for a 10% change in line voltage Load < 0.05% change in output current for a 60% change in rated output voltage Stability and Drift Temperature Coefficient < 100 ppm/C Drift < 0.1% of rating over an eight-hour period after 30 min warmup Filament Specification Voltage 8 VDC , max, referenced to the negative output voltage Current 0.5 to 5 ADC Environmental Operating Temperature 0 to +40C (50 to 104F) Storage Temperature -20 to +70C (-4 to 158F) Humidity 80% max relative humidity up to 31C (88F), reducing linearly to 50% at 40C (104F) non-condensing (ref BS EN61010-1) Altitude Sea level to 2000 m (6500 ) Cooling Fan assisted with fan fail detection. Air inlets at the sides of the unit with exhaust on the rear panel. Minimum air flow required is 3 m/sec at the air intake on the side panels. Usage Indoor use only Installation Category II (BS EN61010) Pollution Degree 2 (BS EN61010) Portability Non-portable 2 advanced-energy.com