Data Sheet INSP-3 Wiring Inspector Tester The INSP-3, wiring inspector is a rugged tester designed to verify building wiring compliance to electrical code, especially voltage drop under load. Identify issues with splices, connections and conductor quality, crucial to safety and performance of the electrical system. n Testing efficiency - relevant test data (voltage, voltage drop, hot and neutral voltage drop, voltage with load, ground impedance) is presented on a single large display to save operator time - no scrolling or switching screens needed n Verifies if wiring is tested for load carrying ability that it meets electrical code recommendations for voltage drop under load n Meter detects faulty wiring in need of repair without removing outlets cover plates, or panel covers: No hassle n Faulty splices and connections warranty n Incorrect wiring No waiting. n Undersized wiring No shipping n Faulty GFCIs, charges. n Faulty or incorrectly wired AFCIs Our commitment to n Incorrect line voltage high-quality products n Poor ground quality and customer service is demonstrated by n User selectable 0, 10,15 and 20 amps loads to verify our industry exclusive performance of the electrical system No Hassle warranty. n Incorrect wiring or voltage drop test failure is clearly indicated In the unlikely event that an Amprobe Test by flashing screen Tool requires warranty n Will not trip circuit breakers or blow fuses during the test service, any of our n Tests GFCI and AFCI operations local dealers are authorized to replace n Check ground quality for safety and ability to support it, on the spot. sensitive electronic equipment (note: 500 MSLP limit) n Measure fault currents n Save money and time by eliminating guess work Amprobe Test Tools www.Amprobe.comData Sheet INSP-3 Wiring Inspector Tester Specifications Load Constant 0, 10, 15 or 20 AMP simulation regardless of line voltage Operating Voltage 95-140 VAC Battery 9V Alkaline Fuse 1/2 Amp, 125 Volt GFI Trip 6.0 mA nominal to trip GFI, 30 mA to trip RCD AFCI Trip Up to 8, 120 AMP pulses within 1/2 second period Operating Temperature 32F to 120F (0 - 50C) Accuracy +/-2%, +/- 2 digits Included Accessories Power Cord 9V Alkaline Battery (Installed) Users Manual Carrying Case Amprobe Test Tools website: www.Amprobe.com email: info amprobe.com Everett, WA 98203 Tel: 877-AMPROBE Amprobe Test Tools Europe In den Engematten 14 79286 Glottertal, Germany Tel.: +49 (0) 7684 8009 - 0 2010 Amprobe Test Tools. All rights reserved. 7/2010 INSP-3 DS Rev A Amprobe Test Tools www.Amprobe.com