FP series Fully illuminated pushbutton switches - momentary or latching Distinctive features and specifications Suited for integrated designs Large but lightweight Pad printed or laser etched symbols Full actuator or symbol illumination, adaptable to design requirements Pad printing Laser Non-illuminated Illuminated ELECTRICAL SPECIFICATIONS MATERIALS Max. current/voltage rating with resistive load : 200mA 12VDC Case : stanyl PA46 Initial contact resistance : 50 m max. Actuator : PA12 Insulation resistance : 1 G min. at 500VDC Bushing/ bezel : PA66 Dielectric strength : 1.000 Vrms 50 Hz min. Contacts : silver, gold plated Electrical life at full load : 300.000 cycles (code 4) Multi-wire lead AWG22 Terminal seal : epoxy or termelt GENERAL SPECIFICATIONS overmolding Panel thickness : 1(.039) to 18 mm (.708) max. Total travel : 2,8 mm 0,5 mm Typical operating force : 8N 2N Mechanical life : 1 million cycles Torque : 3 Nm max. applied to nut Operating temperature : -40C to +75C Dimensions : first dimensions are in mm while inches are shown as bracketted numbers. Tolerance : The general tolerance for dimensions in this brochure is 0,3 (.012). Dimensions, specifications and data shown in this brochure are subject to change without notice. 2 www.apem.com APEMFP series Fully illuminated pushbutton switches - momentary or latching Overview FP SERIES Actuator Electrical function Terminals P Round, flat 1 OFF - ON 1 Solder lugs Model R Round, curved 3 Normally open 2 Straight cable A Threaded bushing, (NO) 3 Right angle dia. 24 mm cable, length 300 mm LED control and No of poles A Non-illuminated, 1 pole B Non-illuminated, 2 poles C Independent, 1 pole D Independent, 2 poles Contact mat. Actuator colour Bezel colour LED colour LED resistor Symbols 4 Silver, gold 1 Blue 1 Blue X Non-illum. 0 No resistor See end of series plated 2 Black 2 Black A Blue supplied 3 Green 3 Green B Green 1 12V resistor Silver on request. 4 Grey 4 Grey C Red 2 24V resistor 5 Yellow 5 Yellow D Yellow 3 48V resistor 6 Red 6 Red E White 7 White/natural 7 White/natural F Red/green Marking 9 Orange G Red/blue X No marking A Maroon 1 Pad printing B Black lacquered 2 Laser ABOUT THIS SERIES On the following pages, you will find successively : model structure of switches and options in the same order as in above chart Dimensions : first dimensions are in mm while inches are shown as bracketted numbers. NOTICE : please note that not all combinations of above numbers are available. Refer to the following pages for further information. Mounting accessories : Standard hardware supplied : 1 hex nut and 1 O-Ring Packaging unit : solder lug versions : 20 pieces - cable versions : 1 piece APEM www.apem.com 3
