C232HM USB 2.0 HI-SPEED TO MPSSE CABLE Datasheet Version 1.3 Document No.: FT 000401 Clearance No.: FTDI 214 Future Technology Devices International Ltd C232HM USB 2.0 Hi-Speed to MPSSE Cable Datasheet Neither the whole nor any part of the information contained in, or the product described in this manual, may be adapted or reproduced in any material or electronic form without the prior written consent of the copyright holder. This product and its documentation are supplied on an as-is basis and no warranty as to their suitability for any particular purpose is either made or implied. Future Technology Devices International Ltd will not accept any claim for damages howsoever arising as a result of use or failure of this product. Your statutory rights are not affected. This product or any variant of it is not intended for use in any medical appliance, device or system in which the failure of the product might reasonably be expected to result in personal injury. This document provides preliminary information that may be subject to change without notice. No freedom to use patents or other intellectual property rights is implied by the publication of this document. Future Technology Devices International Ltd, Unit 1, 2 Seaward Place, Centurion Business Park, Glasgow G41 1HH United Kingdom. Scotland Registered Company Number: SC136640 Copyright Future Technology Devices International Limited 1 D2XX DLL C232HM USB 2.0 HI-SPEED TO MPSSE CABLE Datasheet Version 1.3 Document No.: FT 000401 Clearance No.: FTDI 214 1 Description The USB 2.0 Hi-Speed to MPSSE cable contains a small internal electronic circuit board, utilising the FTDI FT232H, which is encapsulated into the USB connector end of the cable, this handles all the USB signalling and protocols. The cable provides a fast, simple way to connect devices with 3.3 Volt digital interfaces to USB. For full details of the IC, consult the FT232H datasheet, this is available from DS FT232H. The integrated FT232H device incorporates a command processor called the Multi-Protocol Synchronous Serial Engine (MPSSE). The purpose of the MPSSE command processor is to communicate with devices 2 which use synchronous protocols (such as JTAG, SPI or I C) in an efficient manner. Full details are available in the MPSSE application note - AN 108. The cable is terminated by ten individual wires with single pole connectors which can be interfaced to a male header. Cable signals are compliant with CMOS logic at 3.3 volts. The FT232H is a single channel USB 2.0 Hi-Speed (480Mb/s) to UART/FIFO IC. It can be configured in a 2 variety of industry standard serial or parallel interfaces, such as MPSSE - JTAG, SPI, I C. 2 The C232HM MPSSE cable is easily configured into each interface e.g. JTAG, SPI, I C via the application software. The cable is powered from a USB host port and is USB 2.0 Hi-Speed compatible. The cable is 0.5m long and supports a data transfer up to 30Mbps in MPSSE mode. The C232HM MPSSE cable requires USB device drivers, available free from