FT900/1/2/3 Embedded Microcontroller Datasheet Version 1.2 Document No.: BRT 000022 Clearance No.: BRT 025 Future Technology Devices International Ltd. FT900/1/2/3 (Embedded Microcontroller) Two SPI slaves support single data transfer The FT90x series includes the FT900, FT901, with 25MHz clock. FT902 and FT903 which are complete System- 2 On-Chip 32-bit RISC microcontrollers for Two I C bus interfaces can be configured as embedded applications featuring a high level master or slave, which support standard / fast of integration and low power consumption. It / fast plus / high speed mode data transfers. Max data transfer rate up to 3.4 Mbit/s. Clock has the following features: stretching is supported. High performance, low power 32-bit FT32 core 2 I S bus interface can be configured as master processor, running at a frequency of 100MHz. or slave. Two clock input options (24.576 MHz 256kB on-chip Flash memory. 2 and 22.5792 MHz) to support I S master mode for different audio sample rates. 256kB on-chip shadow program memory. UART interface can be configured as one full True Zero Wait States (0WS) up to 3.1 DMIPS programmable UART0 or two simple interfaces, per MHz performance UART0 and UART1 with CTS / RTS control 64kB on-chip data memory. function. EFUSE for security configuration. Four user timers with pre-scaling and a watchdog function. Integrated Phase-Locked Loop (PLL) supports external 12MHz crystal and direct external clock 8-bit parallel data interface supports camera source input. data capturing. 32.768 kHz real time clock support. Support 7 independent PWM channels. Channel 0 and 1 can be configured as PCM 8-bit/16-bit One USB2.0 EHCI compatible host controller stereo audio output. supports high-speed (480 Mbit/s), full-speed (12 Mbit/s), and low-speed (1.5 Mbit/s). SD host controller is compatible to standard specification V3.0, it supports up to 25 MHz SD One USB2.0 peripheral controller supports high- clock speed and software supports SD card speed (480 Mbit/s) and full-speed (12 Mbit/s). format in SD/SDHC/SDXC. USB2.0 host and peripheral controllers support Support two 10-bit DAC 0/1 channels output, the Isochronous, Interrupt, Control, and Bulk sample rate at ~1 MS/s. transfers. Support seven 10-bit ADC 1/7 channels input, 10/100 Mbps Ethernet that is compliant with the sample rate is up to ~960 kS/s. IEEE 802.3/802.3u standards. (FT900 and FT901 only) Single 3.3 volt power supply, built-in 1.2 V regulators. Supports One-Wire debugger for downloading firmware to Flash memory or shadow program 3.3 volt I/O power supply. memory, and supports a software debugger. Support USB Battery Charging Specification Two CAN controllers support CAN protocol 2.0 Rev 1.2. Downstream port can be configured as parts A & B, data rate is up to 1 Mbit/s. (FT900 SDP, CDP or DCP. Upstream port can perform and FT902 only) BCD mode detection. One SPI master supports single / dual / quad Support VBUS power switching and over modes of data transfer. Clock rate is up to 25 current control. MHz Power-On Reset (POR). -40C to 85C extended operating temperature range. Available in compact Pb-free 100-Pin packages (all RoHS compliant). Copyright Bridgetek Limited 1 FT900/1/2/3 Embedded Microcontroller Datasheet Version 1.2 Document No.: BRT 000022 Clearance No.: BRT 025 Neither the whole nor any part of the information contained in, or the product described in this manual, may be adapted or reproduced in any material or electronic form without the prior written consent of the copyright holder. This product and its documentation are supplied on an as-is basis and no warranty as to their suitability for any particular purpose is either made or implied. Future Technology Devices International Ltd will not accept any claim for damages howsoever arising as a result of use or failure of this product. Your statutory rights are not affected. This product or any variant of it is not intended for use in any medical appliance, device or system in which the failure of the product might reasonably be expected to result in personal injury. This document provides preliminary information that may be subject to change without notice. No freedom to use patents or other intellectual property rights is implied by the publication of this document. Future Technology Devices International Ltd, Unit 1, 2 Seaward Place, Centurion Business Park, Glasgow G41 1HH United Kingdom. Scotland Registered Company Number: SC136640 Copyright Bridgetek Limited 2