LC234X Module Datasheet Version 1.1 Document Reference No.: FT 001387 Clearance No.: FTDI 517 Future Technology Devices International Limited Datasheet LC234X Development Module 1.1 Features 1 Introduction The LC234X module utilises the FT234XD The LC234X module is a low cost USB to UART from FTDI. For a full list of the FT234XDs bridge using the FTDI FT234XD to transfer data at features refer to the FT234XD datasheet. up to 3M Baud. Ideal for programming Arduino Pro, ESP modules etc., the pinout follows the In addition, the LC234X module has the industry standard FTDI TTL cable interface. In following features: addition to the 4 data lines (RXD, TXD, RTS, CTS) there is also the option to output 5V power to Small PCB size as 15.24mm X external hardware. The interface IO level may be set to either 3.3V or 5V by an on-board jumper 22.89mm no soldering / de-soldering required. Easy configurable IO voltage interface The LC234X modules UART interface is mapped USB 2.0 full speed to one 1X6 pin header. The module is supplied with one right angle socket and one right angle Low supply current:10mA pin header for maximum flexibility. Supported baud rates: 300 bps to 3 Furthermore there is an LED provided to indicate Mbps data transmission on the UART signals Supplied with one right angle socket and one right angle pin header for maximum flexibility. Power output to external logic 5V o o -40 C to +85 C operational temperature range Full RoHS compliance Neither the whole nor any part of the information contained in, or the product described in this manual, may be adapted or reproduced in any material or electronic form without the prior written consent of the copyright holder. This product and its documentation are supplied on an as-is basis and no warranty as to their suitability for any particular purpose is either made or implied. Future Technology Devices International Ltd will not accept any claim for damages howsoever arising as a result of use or failure of this product. Your statutory rights are not affected. This product or any variant of it is not intended for use in any medical appliance, device or system in which the failure of the product might reasonably be expected to result in personal injury. This document provides preliminary information that may be subject to change without notice. No freedom to use patents or other intellectual property rights is implied by the publication of this document. Future Technology Devices International Ltd, Unit 1, 2 Seaward Place, Centurion Business Park, Glasgow G41 1HH United Kingdom. Scotland Registered Company Number: SC136640 Copyright Future Technology Devices International Limited 1 LC234X Module Datasheet Version 1.1 Document Reference No.: FT 001387 Clearance No.: FTDI 517 2 Typical Applications USB to UART bridge Debugger / Programmer for embedded MCU e.g. Arduino USB IO extender for small 8-bit micros 2.1 Driver Support The LC234X requires USB drivers (listed below), available free from