6ED2230S12T 1200 V Three Phase Gate Driver with Integrated Bootstrap Diode and OCP Features Infineon Thin-Film-SOI technology Product summary Fully operational to +1200 V V 1200 V OFFSET Integrated Ultrafast Bootstrap Diode V = 13 V - 20 V CC Floating channel designed for bootstrap operation I (typ.) = 0.35 A/0.65 A O+/- Output source/sink current capability +0.35 A/0.65 A t (typ.) = 700 ns/650 ns on/off Tolerant to negative transient voltage up to -100 V Deadtime (typ.) = 460 ns (Pulse width is up 700 ns) given by SOI-technology Undervoltage lockout for both channels Package 3.3 V, 5 V, and 15 V input logic compatible Over current protection with 5% ITRIP threshold Fault reporting, automatic Fault clear and Enable function on the same pin (RFE) Matched propagation delay for all channels Integrated 460 ns deadtime protection DSO-24 (DSO-28 with 4 pins removed) Shoot-through (cross-conduction) protection Typical applications Industrial Drives Embedded inverters for Motor Control in Pumps, Fans. Commercial and Lite Commercial Air Conditioning Description The 6ED2230S12T is a high voltage, high speed IGBT with three independent high side and low side referenced output channels for three phase applications. Proprietary HVIC and latch immune CMOS technologies enable ruggedized monolithic construction. The logic input is compatible with standard CMOS or TTL outputs, down to 3.3 V logic. An overcurrent protection (OCP) function which terminates all six outputs can also be derived from this resistor. An open drain FAULT signal is provided to indicate that an over-current or undervoltage shutdown has occurred. Fault conditions are cleared automatically aft er a delay programmed externally via an RC network. The output drivers feature a high-pulse current buff er stage designed for minimum driver cross-conduction. The floating channel can be used to drive N-channel power MOSFETs or IGBTs in the high side configuration which operates up to 1200 V. Propagation delays are matched to simplify the HVICs use in high frequency applications. DC BUS + Vcc VB1,2,3 (Refer to Lead Assignments for Hin1,2,3 Lin1,2,3 correct pin configuration). HO1,2,3 RFE This diagram shows electrical ITRIP VS1,2,3 connections only. Please refer to To load Application Notes & Design Tips for proper circuit board layout. LO1,2,3 Vss COM DC BUS - Figure 1 Typical connection diagram Datasheet Please read the Important Notice and Warnings at the end of this document <Revision 1. 3> 20200310 www.infineon.com/SOI6ED2230S12T 1200 V Three Phase Gate Driver with Integrated Bootstrap Diode and OCP Device information Device information Base part number Package type Standard pack Orderable part pumber Form Quantity 1) 6ED2230S12T DSO-24 Tape and Reel 1000 6ED2230S12TXUMA1 1 Also available for die sales as Sawn Wafer on Film with part number 6ED2230S12C. Please contact Infineon for more information. Datasheet 2