BCR602 hot plug IC with dimming 60 V linear LED controller IC for dimmable LED applications with ripple suppression, overtemperature and hot plug protection Features Supply voltage 8 V to 60 V, Supports use of NPN bipolar transistors and NMOS MOSFETS, AC supply voltage ripple suppression, Dimming at pin MFIO - 3% analog dimming of LED current by resistor R or DC voltage, set - 1% PWM dimming of LED current by PWM signals, R functionality at pin MFIO, set LED current precision 3%. Protection features Hot plug protection, Overtemperature protection. Target applications LED light engines/modules, LED replacement lamps. Advantages with respect to discrete solutions Low BOM count, Lower assembly cost, Smaller form factor, Higher reliability due to less parts and soldering joints. Product validation Qualified for industrial applications according to the relevant tests of JEDEC47/20/22. Device information 6 DRV 1 VS 2 GND 5 TEST 3 4 VSENSE MFIO Figure 1 Pin configuration Datasheet Please read the Important Notice and Warnings at the end of this document Revision 1.1 www.infineon.com 2018-12-3BCR602 hot plug IC with dimming Description Table 1 Part information Type Package Configuration Marking code 60V Linear Current Control PG-SOT23-6 n.a. 602 Chip BCR602 Description BCR602 is a linear LED controller IC regulating the LED current by means of an external driver transistor. BCR602 supports use of NPN bipolar transistors and NMOSFETs to cover a wide LED current and power range up to several hundred mA. The LED current is fully scalable by dimensioning an external current sense resistor. BCR602 suppresses the voltage ripple of the power supply driving a constant LED current for better light quality. The LED current can be dimmed by resistors as well as analog or digital PWM voltages connected to the Multi Function Input Output (MFIO) pin. The embedded hot plug protection allows plug in and plug out of any LED load during operation. The overtemperature protection will dim the LED current if the BCR602 junction temperature threshold is exceeded. In this case the LED current will be reduced to 30% of the nominal current. Once the junction temperature drops below the temperature hysteresis nominal LED current is resumed. The BCR602 is a perfect fit for LED applications by combining small form factor with low cost. Through its higher integration, BOM savings and ensuring long lifetime of LEDs, this controller has many advantages compared to discrete solutions. Datasheet 2 Revision 1.1 2018-12-3