Datasheet Version 2.1, September 2008 ICB1FL02G Smart Ballast Control IC for Fluorescent Lamp Ballasts Power Management & SupplyICB1FL02G Revision History: 2008-09 V 2.1 Previous Version: 2005-06-06 (ICB1FL01G) Page Subjects (major changes since last revision) 19 Min Duration of EOL1 25 Preheating Time updated 26 EOL Current Threshold, AC & DC Previous Version: 2006-02-08 (ICB1FL02G) 3 Package PG-DSO-18-2, halogen-free mould compound, WEEE compliant 11 Function removed and sentence deleted During ignition and prerun mode the notch filter is bypassed. 18 State diagram reworked (frequency range description corrected) 23 PFC zero current detector: clamping of positive voltages 24 PFC section: initial on-time and repetition time adapted 25 Inverter control: minimum duration of fault conditions EOL1, Cap Load 2 adapted 26 Restart after lamp removal: discharge resistor value adapted 33 LC equations corrected Edition 2008-09 Published by Infineon Technologies AG 81726 Munich, Germany 10/16/08 Infineon Technologies AG All Rights Reserved. Legal Disclaimer The information given in this document shall in no event be regarded as a guarantee of conditions or characteristics. With respect to any examples or hints given herein, any typical values stated herein and/or any information regarding the application of the device, Infineon Technologies hereby disclaims any and all warranties and liabilities of any kind, including without limitation, warranties of non-infringement of intellectual property rights of any third party. Information For further information on technology, delivery terms and conditions and prices, please contact the nearest Infineon Technologies Office (www.infineon.com). Warnings Due to technical requirements, components may contain dangerous substances. For information on the types in question, please contact the nearest Infineon Technologies Office. Infineon Technologies components may be used in life-support devices or systems only with the express written approval of Infineon Technologies, if a failure of such components can reasonably be expected to cause the failure of that life-support device or system or to affect the safety or effectiveness of that device or system. Life support devices or systems are intended to be implanted in the human body or to support and/or maintain and sustain and/or protect human life. If they fail, it is reasonable to assume that the health of the user or other persons may be endangered.