TLE72093RAUMA1 Infineon

7 A H-Bridge for DC-Motor Applications TLE7209-3R 1Overview 1.1 Features Operating supply voltage 5 V to 28 V Typical R = 150 m for each output transistor DSon (at 25 C) Continuous DC load current 5 A (T < 100 C) C Output current limitation at typ. 6.6 A 1.1 A Short circuit shut-down for output currents over 8 A Logic- inputs TTL/CMOS-compatible Output switching frequency up to 30 kHz Rise and fall times optimized for 0.5-2 kHz Over-temperature protection Short circuit protection Undervoltage disable function Diagnostic by SPI or Status-Flag (configurable) Enable and Disable inputs PG-DSO-20-65 power package Green Product (RoHS compliant) Functional Description The TLE7209-3R is an intelligent full H-Bridge, designed for the control of DC and stepper motors in safety critical applications and under extreme environmental conditions. The H-Bridge is protected against over-temperature and short circuits and has an under voltage lockout for all the supply voltages V (main DC power supply). All malfunctions S cause the output stages to go tristate. The device is configurable by the DMS pin. When grounded, the device gives diagnostic information via a simple error flag. When supplied with V = 5 V, the device works in CC SPI mode. In this mode, detailed failure diagnosis is available via the serial interface. Type Package TLE7209-3R PG-DSO-20-65 Data Sheet 1 Rev. 1.0, 2014-02-03TLE 7209-3R Overview 1.2 Pin Configuration GND 1 20 GND SCK/SF IN2 2 19 IN1 3 18 DIS NC CSN 4 17 5 16 V V S S OUT1 6 15 OUT2 OUT1 7 14 OUT2 SDO 8 13 EN SDI 9 12 DMS GND 10 11 GND Metal slug is connected to GND pins internally Figure 1 Pinout TLE7209-3R Table 1 Pin Definitions and Functions Pin. No. Symbol Function 1 GND Ground 2 SCK/SF SPI-Clock/Status-flag 3IN1 Input 1 4 NC Not connected 5, 16 V Supply voltage connect pins externally S 6, 7 OUT1 Output 1 connect pins externally 8 SDO Serial data out 9 SDI Serial data in 10 GND Ground 11 GND Ground Data Sheet 2 Rev. 1.0, 2014-02-03