IS42/45VM16320D 8M x 16Bits x 4Banks Mobile Synchronous DRAM Description These IS42/45VM16320D are mobile 536,870,912 bits CMOS Synchronous DRAM organized as 4 banks of 8,388,608 words x 16 bits. These products are offering fully synchronous operation and are referenced to a positive edge of the clock. All inputs and outputs are synchronized with the rising edge of the clock input. The data paths are internally pipelined to achieve very high bandwidth. All input and output voltage levels are compatible with LVCMOS. Features JEDEC standard 1.8V power supply Internal 4 banks operation Auto refresh and self refresh Burst Read Single Write operation All pins are compatible with LVCMOS interface Special Function Support 8K refresh cycles every 16ms (A2 grade) or - PASR(Partial Array Self Refresh) 64ms (Commercial, Industrial, A1 grade) - Auto TCSR(Temperature Compensated Self Refresh) Programmable Burst Length and Burst Type - Programmable Driver Strength Control - 1, 2, 4, 8 or Full Page for Sequential Burst - Full Strength or 1/2, 1/4 or 1/8 of Full Strength - 4 or 8 for Interleave Burst - Deep Power Down Mode Programmable CAS Latency : 2,3 clocks Automatic precharge, includes CONCURRENT Auto Precharge All inputs and outputs referenced to the positive edge of the Mode and controlled Precharge system clock Data mask function by DQM Copyright 2010 Integrated Silicon Solution, Inc. All rights reserved. ISSI reserves the right to make changes to this specification and its products at any time without notice. ISSI assumes no liability arising out of the application or use of any information, products or services described herein. Customers are advised to obtain the latest version of this device specification before relying on any published information and before placing orders for products. Integrated Silicon Solution, Inc. does not recommend the use of any of its products in life support applications where the failure or malfunction of the product can reasonably be expected to cause failure of the life support system or to significantly affect its safety or effectiveness. Products are not authorized for use in such applications unless Integrated Silicon Solution, Inc. receives written assurance to its satisfaction, that: a.) the risk of injury or damage has been minimized b.) the user assume all such risks and c.) potential liability of Integrated Silicon Solution, Inc is adequately protected under the circumstances 1 Rev. A April 2012 www.issi.com - DRAM issi.com IS42/45VM16320D Figure1: 54Ball FBGA Ball Assignment 1 2 3 4 5 6 7 8 9 A VSS DQ15 VSSQ VDDQ DQ0 VDD B DQ14 DQ13 VDDQ VSSQ DQ2 DQ1 C DQ12 DQ11 VSSQ VDDQ DQ4 DQ3 D DQ10 DQ9 VDDQ VSSQ DQ6 DQ5 E DQ8 NC VSS VDD LDQM DQ7 F UDQM CLK CKE /CAS /RAS /WE G A12 A11 A9 BA0 BA1 /CS H A8 A7 A6 A0 A1 A10 J VSS A5 A4 A3 A2 VDD Top View 2 Rev. A April 2012 www.issi.com - DRAM issi.com