IS43LR16320C-5BLI ISSI

IS43/46LR16320C 8M x 16Bits x 4Banks Mobile DDR SDRAM Description The IS43/46LR16320C is 536,870,912 bits CMOS Mobile Double Data Rate Synchronous DRAM organized as 4 banks of 8,388,608 words x 16 bits. This product uses a double-data-rate architecture to achieve high-speed operation. The Data Input/ Output signals are transmitted on a 16-bit bus. The double data rate architecture is essentially a 2N prefetch architecture with an interface designed to transfer two data words per clock cycle at the I/O pins. This product offers fully synchronous operations referenced to both rising and falling edges of the clock. The data paths are internally pipelined and 2n-bits prefetched to achieve very high bandwidth. All input and output voltage levels are compatible with LVCMOS. Features JEDEC standard 1.8V power supply 64ms refresh period (8K cycle) VDD = 1.8V, VDDQ = 1.8V Auto & self refresh Four internal banks for concurrent operation Concurrent Auto Precharge MRS cycle with address key programs Maximum clock frequency up to 200MHZ - CAS latency 2, 3 (clock) Maximum data rate up to 400Mbps/pin - Burst length (2, 4, 8, 16) Power Saving support - Burst type (sequential & interleave) - PASR (Partial Array Self Refresh) Fully differential clock inputs (CK, /CK) - Auto TCSR (Temperature Compensated Self Refresh) All inputs except data & DM are sampled at the rising - Deep Power Down Mode edge of the system clock - Programmable Driver Strength Control by Full Strength Data I/O transaction on both edges of data strobe or 3/4, 1/2, 1/4, or 1/8 of Full Strength Bidirectional data strobe per byte of data (DQS) Status Register Read (SRR) DM for write masking only LVCMOS compatible inputs/outputs Edge aligned data & data strobe output 60-Ball FBGA package Center aligned data & data strobe input Copyright 2013 Integrated Silicon Solution, Inc. All rights reserved. ISSI reserves the right to make changes to this specification and its products at any time without notice. ISSI assumes no liability arising out of the application or use of any information, products or services described herein. Customers are advised to obtain the latest version of this device specification before relying on any published information and before placing orders for products. Integrated Silicon Solution, Inc. does not recommend the use of any of its products in life support applications where the failure or malfunction of the product can reasonably be expected to cause failure of the life support system or to significantly affect its safety or effectiveness. Products are not authorized for use in such applications unless Integrated Silicon Solution, Inc. receives written assurance to its satisfaction, that: a.) the risk of injury or damage has been minimized b.) the user assume all such risks and c.) potential liability of Integrated Silicon Solution, Inc is adequately protected under the circumstances 11 Rev. C Aug. 2013 www.issi.com - dram issi.com IS43/46LR16320C Figure1: 60Ball FBGA Ball Assignment 1 2 3 4 5 6 7 8 9 A VSS DQ15 VSSQ VDDQ DQ0 VDD B VDDQ DQ13 DQ14 DQ1 DQ2 VSSQ C VSSQ DQ11 DQ12 DQ3 DQ4 VDDQ D VDDQ DQ9 DQ10 DQ5 DQ6 VSSQ E VSSQ UDQS DQ8 DQ7 LDQS VDDQ F VSS UDM NC NC LDM VDD G CKE CK /CK /WE /CAS /RAS H A9 A11 A12 /CS BA0 BA1 J A6 A7 A8 A10 A0 A1 K VSS A4 A5 A2 A3 VDD Top View 2 Rev. C Aug. 2013 www.issi.com - dram issi.com