Memory Module Speci cations KVR1333D3N9K4/32G 32GB (8GB 1G x 64-Bit x 4 pcs.) PC3-10600 CL9 240-Pin DIMM Kit DESCRIPTION SPECIFICATIONS ValueRAM s KVR1333D3N9K4/32G is a kit of four 1G x 64-bit CL(IDD) 9 cycles (8GB) DDR3-1333 CL9 SDRAM (Synchronous DRAM) 2Rx8, Row Cycle Time (tRCmin) 49.125ns(min.) memory modules, based on sixteen 512M x 8-bit FBGA 260ns(min.) Refresh to Active/Refresh components per module. Total kit capacity is 32GB. The SPDs Command Time (tRFCmin) are programmed to JEDEC standard latency DDR3-1333 timing Row Active Time (tRASmin) 36ns(min.) of 9-9-9 at 1.5V. Each 240-pin DIMM uses gold contact fingers. Maximum Operating Power (per module) TBD W* The electrical and mechanical specifications are as follows: UL Rating 94 V - 0 o o Operating Temperature 0 C to +85 C o o Storage Temperature -55 C to +100 C FEATURES *Power will vary depending on the SDRAM. JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply VDDQ = 1.5V (1.425V ~ 1.575V) 667MHz fCK for 1333Mb/sec/pin 8 independent internal banks Programmable CAS latency: 9, 8, 7, 6 Programmable Additive Latency: 0, CL - 2, or CL - 1 clock 8-bit pre-fetch Burst Length: 8 (interleave without any limit, sequential with starting address 000 only), 4 with tCCD = 4 which does not allow seamless read or write (either on the fly using A12 or MRS) Bi-directional Differential Data Strobe Internal (self) calibration: Internal self calibration through ZQ pin (RZQ: 240 ohm 1%) On Die Termination using ODT pin Average Refresh Period 7.8us at lower than TCASE 85C, 3.9us at 85C < TCASE < 95C Asynchronous Reset PCB: Height 0.740 (18.75mm) or 1.180 (30.00mm) Important Information: The module defined in this data sheet is one of several configurations available under this part number. While all configurations are compatible, the DRAM combination and/or the module height may vary from what is described here. Continued >> kingston.com Document No. VALUERAM1034-001.D00 03/26/15 Page 1MODULE DIMENSIONS kingston.com Document No. VALUERAM1034-001.D00 Page 2