AMC-143SMA MACOM

AM-143 / AMC-143 Low Noise Amplifier, 16 dB Gain, Rev. V4 5 - 500 MHz Features TO-8-1 1.9 dB Typical Midband Noise Figure +7 dBm Typical Midband Output Power +20 dBm Typical Third Order Intercept Description M/A-COMs AM-143 is a coupler feedback amplifier with low noise figure and high intercept points for the low bias current. The use of coupler feedback minimizes noise figure and current in a high intercept amplifier. This amplifier is packaged in a TO-8 package. The ground plane on the PC board should be configured to remove heat from under the package. AM-143 are ideally suited for use where a low noise, high reliability amplifier is required. Ordering Information Part Number Package 3 AM-143 PIN TO-8-1 AMC-143 SMA Connectorized 3. Mounting kit part number AU00071 required for PCB applications. * Outline Drawing: SMA Connectorized 1 Absolute Maximum Ratings Parameter Absolute Maximum Max. Input Power +20 dBm Vbias +15.75 V Operating Temperature -55C to +85C Storage Temperature -65C to +125C 1. Operation of this device above any one of these parameters may cause permanent damage. Dimensions are inches (millimeters) 0.015 (0.38) unless otherwise specified. 11 1 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: AM-143 / AMC-143 Low Noise Amplifier, 16 dB Gain, Rev. V4 5 - 500 MHz 2, Electrical Specifications: TA = -55C to +85C Case Temperature Parameter Test Conditions Frequency Units Min. Typ. Max. o Gain +25 C 50 MHz dB 15.3 15.8 16.3 Frequency Response 5 - 500 MHz dB 1.0 Gain Variation with 5 - 500 MHz dB 0.8 Temperature 1 dB Compression Output Power 5 - 500 MHz dBm +4 Noise Figure 5 - 500 MHz dB 3.5 5 - 100 MHz 2.7 Reverse Transmission 5 - 500 MHz dB -21 -16 VSWR 5 - 500 MHz Ratio 2.5:1 Output IP Two-Tone inputs up to -10 dBm 5 - 500 MHz dBm +24 2 Output IP Two-Tone inputs up to -10 dBm 5 - 500 MHz dBm +16 3 Vbias VDC +14.5 +15.0 +15.5 Ibias Vbias = +15.0 VDC mA 13 15 Power Dissipation +15 V Bias mW 200 2. All specifications apply when operated at +15 VDC, with 50 ohms source and load impedance. S-Parameter Data Frequency S11 S21 S12 S22 (MHz) MAG/ANG MAG/ANG MAG/ANG MAG/ANG 5 0.20/-60.7 5.90/-161.0 0.09/-160.5 0.32/-24.9 10 0.12/-63.8 6.07/-171.8 0.09/-172.6 0.27/-24.9 20 0.09/-65.3 6.16/-179.8 0.10/178.9 0.26/-17.4 50 0.10/-82.7 6.08/167.5 0.10/166.3 0.25/-28.0 100 0.14/-101.0 6.06/153.3 0.10/150.5 0.26/-49.3 200 0.21/-130.6 6.00/126.7 0.10/119.8 0.26/-82.3 300 0.23/-149.2 6.01/100.9 0.10/93.6 0.24/-104.5 400 0.20/-155.5 6.09/70.7 0.10/67.4 0.22/-100.5 500 0.22/-142.9 6.11/36.8 0.10/43.3 0.20/-79.8 22 2 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: