AMS-162-PIN MACOM

AM- / AMC- / AMS-162 Low Noise Amplifier, 12.5 dB Gain, Rev. V5 10 - 100 MHz Features TO-8-1 1.1 dB Typical Low Noise Figure 50 MHz +15 dBm Typical High Output Power 50 MHz +32 dBm Typical Third Order Intercept 50 MHz Fully Hermetic Package (AM-162, AMS-162) Description M/A-COMs AM-162 is a coupler feedback amplifier with high intercept and compression points. The use of coupler feedback minimizes noise figure and current in a high intercept amplifier. This amplifier is packaged in a TO-8-1 package, a surface mount package and a connectorized version. The ground plane on the PC board should be configured to remove heat from under the package. AM-162 are ideally suited for use where a high intercept, high reliability amplifier is required. * Outline Drawing: SMA Connectorized SF-1 Dimensions are inches (millimeters) 0.015 (0.38) unless otherwise specified. 1 Absolute Maximum Ratings Parameter Absolute Maximum Pin Configuration (For AMS-162) Max. Input Power +10 dBm Vbias +15.75 V Pin No. Function Pin No. Function Operating Temperature -55C to +85C 1 RF OUT 3 RF IN Storage Temperature -65C to +125C 2 VDC 4 GND 1. Operation of this device above any one of these parameters 11 1 may cause permanent damage. 1 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: AM- / AMC- / AMS-162 Low Noise Amplifier, 12.5 dB Gain, Rev. V5 10 - 100 MHz 2 Electrical Specifications: TA = -55C to +85C Case Temperature Parameter Test Conditions Frequency Units Min. Typ. Max. o Gain +25 C 50 MHz dB 12.0 12.5 13.0 Frequency Response 10 - 100 MHz dB 0.6 Gain Variation with 10 - 100 MHz dB 0.6 Temperature 1 dB Compression Output Power 10 - 100 MHz dBm +13 Noise Figure 10 - 100 MHz dB 1.6 Reverse Transmission 10 - 100 MHz dB -15 -14 VSWR 10 - 100 MHz Ratio 2.0:1 Output IP Two-Tone inputs up to 0 dBm 10 - 100 MHz dBm +40 2 Output IP Two-Tone inputs up to 0 dBm 10 - 100 MHz dBm +26 3 Vbias VDC +14.5 +15.0 +15.5 Ibias mA 11 15 Vbias = +15.0 VDC Power Dissipation mW 165 +15 V Bias 2. All specifications apply when operated at +15 VDC, with 50 ohms source and load impedance. S-Parameter Data Frequency S11 S21 S12 S22 (MHz) MAG/ANG MAG/ANG MAG/ANG MAG/ANG 10 0.07/165 4.06/66 0.18 0.09/169.1 20 0.09/-166.8 4.13/-6.5 0.17 0.09/-159.2 30 0.08/-151.5 4.18/-15.8 0.17 0.09/-129.5 40 0.10/-146.9 4.20/-24.0 0.17 0.11/-120.3 50 0.11/-147.9 4.23/-32.2 0.17 0.12/-117.7 1 60 0.11/-152.0 4.19/-39.8 0.17 0.13/-118.5 70 0.12/-159.7 4.20/-47.7 0.17 0.14/-120.3 85 0.12/-171.2 4.17/-59.5 0.16 0.14/-122.6 100 0.12/174.1 4.15/-72.1 0.16 0.15/-123.6 22 2 2 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: