MABA-007237-ETC410 MACOM

MABA-007237-ETC410 E-Series RF 1:4 Coupled Step-Up Transformer Rev. V3 1 - 350 MHz Features Schematic Surface mount 5 4 3 Wide frequency range SEC 1:4 Impedance Ratio CT on Secondary Lead Free RoHS* Compliant and is 2600C reflow compatible. Available on Tape and Reel, reel quantity 2000 PRI 1 2 Pin Configuration Pin Function Pin Function 1 Primary Dot 4 Secondary CT 2 Primary 5 Secondary Dot 3 Secondary Electrical Specifications: RF Freq. = 1 - 350 MHz, T = +25C, P = 0 dBm A IN Parameter Test Conditions & Frequency Units Min. Typ. Max. FL - fU 5 - 100 MHz 1.0 Insertion Loss dB 2 - 300 MHz 1.21 2.0 1 - 350 MHz 3.0 5 - 100 MHz 0.1 Amplitude Unbalance dB 1 - 350 MHz 0.5 5 - 100 MHz 1.0 Phase Unbalance Degrees 1 - 350 MHz 5.0 1,2 Recommended Maximum Ratings Parameter Absolute Maximum DC Power 250 mW Ordering Information DC Current 30 mA Part Number Description Operating Temperature -40C to +85C Storage Temperature -55C to +125C MABA-007237-ETC410 2000 piece reel 1. Exceeding any one or combination of these limits may cause permanent damage to this device. 2. MACOM does not recommend sustained operation near these survivability limits. 11 1 MACOM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: MABA-007237-ETC410 E-Series RF 1:4 Coupled Step-Up Transformer Rev. V3 1 - 350 MHz Typical Performance Curves Insertion Loss Phase Balance 0 200 -0.4 190 -0.8 180 -1.2 170 -1.6 160 0 70 140 210 280 350 0 70 140 210 280 350 Frequency (MHz) Frequency (MHz) Amplitude Balance 0.2 0.1 0.0 -0.1 -0.2 0 70 140 210 280 350 Frequency (MHz) 22 2 MACOM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: