MD-149-PIN MACOM

MD- / MDS-149 Double-Balanced Mixer, Rev. V4 10 - 1500 MHz Features FP-2 (MD-149) Over Two-Decade Frequency Range Conversion Loss: 6 dB Typical Midband LO-RFIsolation: 40 dB Typical Midband Fully Hermetic Package Impedance: 50 Ohms Nominal Maximum Input Power: 300 mW Max, Derated to 85C 3.2 mW/C IF Port Current: 50 mA Max. MIL-STD-883 Screening Available Description Transformers convert the LO and RF paths to balanced lines connecting to a medium barrier, Schottky diode ring quad. These transformers help provide excellent isolation between ports. Conversion loss is low. The direct connection of the IF port to the diode quad allows these mixers to be used as phase detectors and bi-phase modulators. SF-1 (MDS-149) Pin Configuration (MD-149) Pin No. Function Pin No. Function 1 GND 5 LO 2 GND 6 GND 3 GND 7 GND 4 IF 8 RF Pin Configuration (MDS-149) Pin No. Function Pin No. Function 1 GND 3 LO 2 IF 4 RF 1 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: MD- / MDS-149 Double-Balanced Mixer, Rev. V4 10 - 1500 MHz 1 Electrical Specifications : T = -55C to +85C A Parameter Test Conditions Frequency Units Min Typ Max Frequency Range RF, LO Ports 10 - 1500 MHz IF Port DC - 1500 MHz Conversion Loss 10 - 1000 MHz dB 7.5 1000 - 1500 MHz dB 10 Isolation LO to RF 10 - 100 MHz dB 35 100 - 1000 MHz dB 30 1000 - 1500 MHz dB 20 LO to IF 10 - 100 MHz dB 35 100 - 1000 MHz dB 20 1000 - 1500 MHz dB 12 RF to IF 10 - 100 MHz dB 30 100 - 1000 MHz dB 18 1000 - 1500 MHz dB 8 DC Polarity Negative DC Offset mV <4 RF Input 1 dB Compression dBm 0 1 dB Desensitization dBm -2.0 SSB Noise Figure Within 1 dB of Conversion Loss Max Typical Two-Tone IM with a 10 dBm input, each input, 100-500 MHz dB 48 Ratio 25 MHz and 35 MHz IF 500-1000 MHz dB 43 1000-1500 MHz dB 35 1. All specifications apply when operated at +7 dBm available LO power with 50 ohm source and load impedance. Bottom View of SF-1 Typical Performance Curves 4X .016 .002 .506 .385 Ref .220 .381 .165 .002 .000 2 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: