Termination Insensitive Mixer 1 MHz - 3.5 GHz MDx-169 Rev. V8 Features C-7 (MDC-169) Intermodulation Ratio is Insensitive to Port Mismatches VSWR: <2.0:1 Midband Isolation: 35 dB Midband Impedance: 50 Nominal Input Power: 350 mW Max. 25C, Derated to 85C 3.2 mW/C LO Power: 24 dBm Max. MIL-STD-883 Screening Available Applications Aerospace & Defense 1 SF-1 (MDS-169) ISM Description The unique design of the termination insensitive mixer (TIM) enables it to apply high reverse voltage to diodes during their off phase, in the LO cycle. This allows for higher power level performance with minimum distortion. In addition the TIM has internal loads that provide a good match and also absorb mixer generated LO frequency terms. Combined, these features give the mixer its insensitivity to 1 FP-2 (MD-169) external mismatches, plus superior VSWR. Ordering Information Part Number Package MDC-169-SMA C-7 MDS-169-PIN SF-1 MD-169-PIN FP-2 1. All pins not marked are ground pins. 11 1 MACOM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: htt p s:// ww w.m a com . com / su p por t DC-0003916 Termination Insensitive Mixer 1 MHz - 3.5 GHz MDx-169 Rev. V8 2 Electrical Specifications : Freq. RF & LO Ports = 0.001 - 3.5 GHz, IF Port = 5 - 1500 MHz, T = -55C to +85C A Parameter Test Conditions Units Min. Typ. Max. LO +10 dBm, IF 60 MHz 3 5 - 1000 MHz 7 Conversion Loss dB 1000 - 3000 MHz 9 1 - 3500 MHz 10 LO to RF & LO to IF 5 - 1000 MHz 30 1 - 3500 MHz 20 Isolation dB RF to IF 10 - 500 MHz 30 1 - 3000 MHz 20 1 - 3500 MHz 18 1 dB Compression 7 RF Input dBm 1 dB Desensitization 5 Within 1 dB of SSB Noise Figure dB Conversion Loss Max. P = -10 dBm per tone, IF = 60 MHz IN 10 MHz 55 Typical Two-Tone IM Ratio dB 500 MHz 58 3000 MHz 56 3rd Order IF VSWR 3:1 dB 3 Intermodulation Ratio Degradation 2. All specifications apply when operated at 10 dBm available LO power with 50 source and load impedance. 3. For MDC-169, add 1 dB to conversion loss. 4 Absolute Maximum Ratings (MDS-169) Parameter Absolute Maximum 350 mW o Total Power Derated at 85 C o 3.2 mW/ C LO Power 24 dBm 4. Operation of this device above any one of these parameters may cause permanent damage. 22 2 MACOM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: htt p s:// ww w.m a com . com / su p por t DC-0003916