1000W Intelligent Single Output Battery Charger PB-1000 series * / % & ( ) * & ) +* +*,- .% + / 0 ) + 1 2) ) 2) 34 & 2 2** & 5 6 * Bauart gepruft 7 Sicherheit egelma ge od os be wac g www.tuv.com ID 2000000000 SPECIFICATION MODEL PB-1000-12 PB-1000-24 PB-1000-48 BOOST CHARGE VOLTAGE Vboost 14.4V 28.8V 57.6V FLOAT CHARGE VOLTAGE Vfloat 13.8V 27.6V 55.2V OUTPUT CURRENT 60A 34.7A 17.4A RECOMMENDED BATTERY OUTPUT 200 ~ 600Ah 120 ~ 350Ah 60 ~ 175Ah CAPACITY(AMP HOURS)(Note 4) BATTERY TYPE Open & Sealed Lead Acid LEAKAGE CURRENT FROM <1mA BATTERY (Typ.) VOLTAGE RANGE 90 ~ 264VAC 127 ~ 370VDC FREQUENCY RANGE 47 ~ 63Hz POWER FACTOR (Typ.) 0.95/230VAC 0.98/115VAC at full load EFFICIENCY (Typ.) 85% 88% 89% INPUT 12A/115VAC 5.2A/230VAC AC CURRENT (Typ.) INRUSH CURRENT (Typ.) 25A/115VAC 50A/230VAC LEAKAGE CURRENT <3.5mA / 240VAC 16 ~ 18V 32 ~ 35V 64.5 ~ 69.5V OVER VOLTAGE PROTECTION Protection type : Shut down o/p voltage, re-power on to recover Shut down o/p voltage, recovers automatically after temperature goes down OVER TEMPERATURE SHORT CIRCUIT YES, protected by internal circuit REVERSE POLARITY YES, protected by internal circuit Open: Normal work Short: Stop Charging REMOTE CONTROL BATTER BANKS 2 banks (A & B) FAST CHARGE 2 / 3 / 8 stage selectable FUNCTION Relay contact rating(max.): 30V/1A resistive Shor when the unit is working properly,Opewhen the unit is failure or the protection function is activating CHARGER OK OUTPUT OK Relay contact rating(max.): 30V/1A resistive Shor when the battery is full,Ope when the battery is still charging TEMPERATURE COMPENSATION By NTC, compensate both banks at the same time WORKING TEMP. -20 ~ +60 (Refer toDerating Curv) 20 ~ 90% RH non-condensing WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY -40 ~ +85, 10 ~ 95% RH TEMP. COEFFICIENT 0.05%/ (0 ~ 50) VIBRATION 10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes SAFETY STANDARDS UL60950-1, TUV EN60950-1 approved WITHSTAND VOLTAGE I/P-O/P:3KVAC I/P-FG:2KVAC O/P-FG:0.5KVAC SAFETY & EMC ISOLATION RESISTANCE I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25/ 70% RH (Note 3) EMC EMISSION Compliance to EN55022 (CISPR22), EN61000-3-2,-3 EMC IMMUNITY Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, criteria A 127.4K hrs min. MIL-HDBK-217F (25) MTBF 300*184*70mm(L*W*H) OTHERS DIMENSION 3.5Kg 4pcs/15Kg/1.83CUFT PACKING 8 + ) 3 93 NOTE 26 -: % 6 7 7 7 8 6 8 3 ) 6 9 < + = % + > 7 7 File Name:PB-1000-SPEC 2015-12-15A B A B Stage 8/3/2 1 2 3 4 5 6 7 8 9 10 1000W Intelligent Single Output Battery Charger PB-1000 series Mechanical Specification Case No. 804B Unit:mm 300 70 155 72.6 7 LED Loading Indicator Air flow direction 48 26.5 LED Loading Indicator Status Table Status Steady Flashing Color Red Abnormal status Orange Charging Green Full Charging Control Pin No. Assignment(CN100) : HRS DF11-10DP-2DS or equivalent 1 9 7 5 3 Mating Housing HRS DF11-10DS or equivalent 10 8 6 4 2 Terminal HRS DF11-**SC or equivalent CN100 Pin No. Function Description RY13 : Battery Bank A OK relay. 1,2 RY13 Relay contact rating(max.) : 30V/1A resistive. Shor when the battery A is full,Ope when the battery A is still charging. RY14 : Battery Bank B OK relay. 3,4 RY14 Relay contact rating(max.) : 30V/1A resistive. Shor when the battery B is full,Ope when the battery B is still charging. RY15 : Charger OK relay. 5,6 RY15 Relay contact rating(max.) : 30V/1A resistive. Shor when the unit is working properly, Ope when the unit is failure or the protection function is activating. NTC / GND : Temperature sense 7 GND Temperature sensor comes along with the charger can be connected to the unit to allow temperature compensation of the charging voltage. NTC(5K) 8 If the temperature sensor is not used, the charger still works normally. RTH Remote ON/OFF function. 9,10 Turn the output on and off by electrical or dry contact between pin 10 (RC+) and pin 9(RC-). RC- / RC+Ope : Normal work Shor : Stop charging File Name:PB-1000-SPEC 2015-12-15 184 70 22 22 10 ON/OFF INLET SWITCH ON OFF AC INPUT