Atmel 8-bit AVR Microcontroller with 2K Bytes In-System Programmable Flash ATtiny261A Appendix A and B ATtiny261A Specification at 105C and 125C This document contains information specific to devices operating at temperatures up to 125C. Only deviations are covered in this appendix, all other information can be found in the complete datasheet. The complete datasheet can be found at www.atmel.com. Rev. 8197EAVR11/2014 Atmel-8197E-AVR-ATtiny261A-Specification-at-105C-and-125C-Datasheet 11/20141. Electrical Characteristics 1.1 Absolute Maximum Ratings* *NOTICE: Stresses beyond those listed under Absolute Operating Temperature ..................................-55C to +125C Maximum Ratings may cause permanent damage to the device. This is a stress rating Storage Temperature......................................-65C to +150C only and functional operation of the device at Voltage on any Pin except RESET these or other conditions beyond those indi- with respect to Ground ............................... -0.5V to V +0.5V cated in the operational sections of this speci- CC fication is not implied. Exposure to absolute Voltage on RESET with respect to Ground .....-0.5V to +13.0V maximum rating conditions for extended peri- ods may affect device reliability. Maximum Operating Voltage .............................................6.0V DC Current per I/O Pin .................................................40.0mA DC Current V and GND Pins..................................200.0mA CC 1.2 DC Characteristics Table 1-1. DC Characteristics. T = -40 C to +125 C, V = 1.8V to 5.5V (unless otherwise noted). A CC (1) SymbolParameter Condition Min Typ Max Units Except XTAL1 and (3) -0.5 0.2V V CC RESET pins XTAL1 pin, (3) -0.5 0.1V V V Input Low-voltage CC IL External Clock Selected (3) RESET pin -0.5 0.2V V CC (3) RESET pin as I/O -0.5 0.2V V CC Except XTAL1 and (2) 0.7V V +0.5 V CC CC RESET pins XTAL1 pin, (2) 0.8V V +0.5 V V Input High-voltage CC CC IH External Clock Selected (2) RESET pin 0.9V V +0.5 V CC CC (2) RESET pin as I/O 0.7V V +0.5 V CC CC (4) Output Low Voltage I = 10mA, V = 5V 0.6 V OL CC V (6) OL (Except Reset pin) I = 5mA, V = 3V 0.5 V OL CC (5) Output High-voltage I = -10mA, V = 5V 4.3 V OH CC V (6) OH (Except Reset pin) I = -5mA, V = 3V 2.5 V OH CC Input Leakage V = 5.5V, pin low CC I < 0.05 1 A IL Current I/O Pin (absolute value) Input Leakage V = 5.5V, pin high CC I < 0.05 1 A IH Current I/O Pin (absolute value) R Reset Pull-up Resistor 30 60 k RST R I/O Pin Pull-up Resistor 20 50 k PU 2 ATtiny261A PRELIMINARY DATASHEET Atmel-8197E-AVR-ATtiny261A-Specification-at-105C-and-125C-Datasheet 11/2014