PIC16(L)F1773/6
28-Pin, 8-Bit Flash Microcontroller
Description
PIC16(L)F1773/6 microcontrollers feature a high level of integration of intelligent analog and digital peripherals for a
wide range of applications, such as lighting, power supplies, battery charging, motor control and other general purpose
applications. These devices deliver multiple op amps, 5-/10-bit DACs, high-speed comparators, 10-bit ADC, 10-/16-bit
PWMs, programmable ramp generator (PRG) and other peripherals that can be connected internally to create closed-
loop systems without using pins or the printed circuit board (PCB) area. The 10-/16-bit PWMs, digital signal modulators
and tri-state output op amp can be used together to create a LED dimming engine for lighting applications. The
peripheral pin select (PPS) functionality provides flexibility, eases PCB layout and peripheral utilization by allowing
digital peripheral pin mapping to an I/O.
Core Features eXtreme Low-Power (XLP) Features
Sleep mode: 50 nA @ 1.8V, typical
C Compiler Optimized RISC Architecture
Watchdog Timer: 500 nA @ 1.8V, typical
Only 49 Instructions
Secondary Oscillator: 500 nA @ 32 kHz
Operating Speed:
Operating Current:
- DC 32 MHz clock input
- 8 uA @ 31 kHz, 1.8V, typical
- 125 ns minimum instruction cycle
- 32 uA/MHz @ 1.8V, typical
Interrupt Capability
16-Level Deep Hardware Stack
Intelligent Analog Peripherals
Five 8-Bit Timers
Three 16-Bit Timers
10-Bit Analog-to-Digital Converter (ADC):
Low-Current Power-on Reset (POR)
- Up to 28 external channels
Configurable Power-up Timer (PWRT)
- Conversion available during Sleep
Brown-out Reset (BOR) with Selectable Trip Point
Three Operational Amplifiers (OPA):
Extended Watchdog Timer (EWDT):
- Selectable internal and external channels
- Low-power 31 kHz WDT
- Tri-state output
- Software selectable prescaler
- Part of LED dimming engine
- Software selectable enable
- Selectable internal and external channels
Six High-Speed Comparators (HS Comp):
Memory
- Up to nine external inverting inputs
Up to 28 Kbytes Program Flash Memory (PFM)
- Up to 12 external non-inverting inputs
Up to 2 Kbytes Data RAM - Fixed Voltage Reference at inverting and
Direct, Indirect and Relative Addressing modes non-inverting input(s)
High-Endurance Flash (HEF):
- Comparator outputs externally accessible
- 128B of nonvolatile data storage Digital-to-Analog Converters (DAC):
- 100K Erase/Write cycles - Three 10-bit resolution DACs
- 10-bit resolution, rail-to-rail
- Conversion during Sleep
Operating Characteristics
- Internal connections to ADCs and HS
Operating Voltage Range:
Comparators
- 1.8V to 3.6V (PIC16LF1773/6)
Voltage Reference:
- 2.3V to 5.5V (PIC16F1773/6)
- Fixed Voltage Reference (FVR)
Temperature Range:
- 1.024V, 2.048V and 4.096V output levels
- Industrial: -40C to 85C
Zero-Cross Detector (ZCD):
- Extended: -40C to 125C
- Detect high-voltage AC signal
Three Programmable Ramp Generators (PRG):
- Slope compensation
- Ramp generation
High-Current Drive I/Os:
- Up to 100 mA sink or source @ 5V
2015-2016 Microchip Technology Inc. DS40001810B-page 1PIC16(L)F1773/6
Peripheral Pin Select (PPS):
Digital Peripherals
- I/O remapping of digital peripherals
Four Configurable Logic Cells (CLC):
Serial Communications:
- Integrated combinational and state logic
- Enhanced USART (EUSART)
Three Complementary Output Generators (COG):
2
- SPI, I C, RS-232, RS-485, LIN compatible
- Push-pull, Full-Bridge and Steering modes
- Auto-Baud Detect, auto-wake-up on start
Three Capture/Compare/PWM (CCP) Modules
Up to 25 I/O Pins:
Pulse-Width Modulator (PWM):
- Individually programmable pull-ups
- Three 16-bit PWMs
- Slew rate control
- Independent timers
- Interrupt-on-change with edge-select
- Multiple output modes (Edge-, Center-
Aligned, set and toggle on register match)
Clocking Structure
- User settings for phase, duty cycle, period,
offset and polarity Precision Internal Oscillator:
- 16-bit timer capability
- 1% at calibration
- Three 10-bit PWMs
- Selectable frequency range 32 MHz to
Digital Signal Modulator (DSM): 31 kHz
- Modulates a carrier signal with a digital data
31 kHz Low-Power Internal Oscillator
to create custom carrier synchronized output
4x Phase-Locked Loop (PLL) for up to 32 MHz
waveforms
Internal Operation
- Part of LED dimming engine
External Oscillator Block with Three External
Clock modes up to 32 MHz
TABLE 1: PIC16(L)F1773/6/7/8/9 FAMILY TYPES
Device
PIC16(L)F1773 (A) 7K 4K 128 512 25 5/3 6 17 3/3 3 3/3 3 4 3 1 3 2 Y 1 1 I/H
PIC16(L)F1776 (A) 14K 8K 128 1K 25 5/3 6 17 3/3 3 3/3 3 4 3 1 3 2 Y 1 1 I/H
PIC16(L)F1777 (B) 14K 8K 128 1K 36 5/3 8 28 4/4 4 4/4 4 4 4 1 4 2 Y 1 1 I/H
PIC16(L)F1778 (B) 28K 16K 128 2K 25 5/3 6 17 3/3 3 3/3 3 4 3 1 3 2 Y 1 1 I/H
PIC16(L)F1779 (B) 28K 16K 128 2K 36 5/3 8 28 4/4 4 4/4 4 4 4 1 4 2 Y 1 1 I/H
Note 1: One pin is input-only.
2: I Debugging integrated on chip; H Debugging via ICD header.
Data Sheet Index:
A: DS40001810 PIC16(L)F1773/6 Data Sheet, 28-Pin, 8-bit Flash Microcontrollers
B: Future Release PIC16(L)F1777/8/9 Data Sheet, 28/40/44-Pin, 8-bit Flash Microcontrollers
Note: For other small form-factor package availability and marking information, please visit