MIKROE-1199 MikroElektronika

2. Soldering the headers Before using your click board, make sure to solder 1x8 male headers to both left and right side of the board. Two 1x8 male headers are included with the board in the package. 1 Flash click 2 3 1. Introduction 4. Essential features Flash Click with its M25P80 module gives additional 8Mb of Flash memory to your design. The M25P80 supports high- performance commands for clock frequency Turn the board upside down so that Turn the board upward again. Make sure up to 75MHz. It is divided in 16 sectors, each bottom side is facing you upwards. Place to align the headers so that they are containing 256 pages. Each page is 256 bytes shorter parts of the header pins in both perpendicular to the board, then solder the wide. Memory can be viewed either as 4,096 soldering pad locations. pins carefully. pages or as 1,048,576 bytes. Flash Click is an accessory board in mikroBUS form factor. Its a compact and 3. Plugging the board in easy solution for adding more flash memory click to your device. It features M25P80 - 8Mb Once you have soldered the headers your serial Flash memory module with advanced board is ready to be placed into desired BOARD hardware write protection mechanisms. mikroBUS socket. Make sure to align the www.mikroe.com Flash Click communicates with the cut in the lower-right part of the board target board via SPI interface. The board is with the markings on the silkscreen at the Flash click Manual designed to use 3.3V power supply only. It mikroBUS socket. If all of the pins are ver. 1.00 has a LED diode (GREEN) that indicates the aligned correctly, push the board all presence of power supply. the way into the socket. 0 100000 0210576. Power supply - 3.3V only 5. Flash Click Board Schematic The board is designed to use 3.3V power supply only. If you need to add serial Flash memory module to your 5V development board, we recommend you to use other boards such as the SerialFlash board: