MIKROE-202 MikroElektronika

Serial 7-Seg Display 2 Manual All Mikroelektronikas development systems feature a large number of peripheral modules expanding microcontrollers range of application and making the process of program testing easier. In addition to these modules, it is also possible to use numerous additional modules linked to the development system through the I/O port connectors. Some of these additional modules can operate as stand-alone devices without being connected to the microcontroller. MikroElektronika Additional Board2 Serial 7-Seg Display 2 Additional Board The Serial 7-Seg Display 2 additional board features eight 7-segment displays used to display digits. Connection between the additional board and a development system is established via an IDC10 connector on the board and a 2x5 connector on one of the developmet systems ports. Communication between the additional board and a microcontroller is performed via a Serial Peripheral Interface (SPI), whereas eight 7-segment displays on the additional board are used to display digits. When connecting the board to a development system, it is necessary to set the appropriate switches on the DIP switch SW1 to the ON position. In case EasyPIC, LV18F, EasyLV-18F, Easy24-33 and BigPIC development systems are used, the following switches on the DIP switch SW1 should be set to the ON position: Switch 1 - MOSI Switch 4 - SCK For EasyAVR and Easy8051 development systems, the following switches on the DIP switch SW1 should be set to the ON position: Switch 3 - MOSI Switch 6 - SCK For the EASYdsPIC development system, the following switches on the DIP switch SW1 should be set to the ON position: Switch 2 - MOSI Switch 5 - SCK Switches 7 and 8 on the DIP switch SW1 are used for connecting the CS pin (Chip Select) on the additional board to a development system. CS lines may be connected to different I/O port pins. Accordingly, it is necessary to define in the program, to be loaded into the microcontroller, which pins will be used as the CS pin (Chip Select). IDC10 connector used to connect a development system Figure 1: Serial 7-Seg Display 2 additional board Displaying digits is enabled by the time-division multiplexing. All the operations related to multiplexing and displaying digits are performed by using the MAX7219 circuit provided on the additional board. The time-division multiplexing of a 7-segment display is based on fast turning the display segments on/off in such a manner that one gets impression that all eight digits are active at the same time. The MAX7219 circuit feeds digit segments with a signal via pins marked SEGxx, whereas pins marked DIGx are used to select one of eight displays to show the appropriate number. MikroElektronika