63910-1470 Molex

T2 Terminator for Low Force Micro-Fit 3.0 Crimp Terminal T2 Terminator Tooling Application Tooling Specification Sheet Order No. 63910-1400 FEATURES It is ideally suited for mid-volume bench operations This terminator can be installed in the TM42 and the TM40 press or Base Unit adapter for 3BF press Quick punch removal with the push of a button for fast and easy tooling change Track adjustment capabilities in the T2 Terminators for improved control of the bell mouth size and cutoff tab length T2 Terminator has standardized tooling with the Molex FineAdjust Applicator which will reduce your inventory requirements SCOPE Products: Low Force Micro-Fit 3.0 Crimp Terminal, 20-24 AWG. Wire Size Insulation Diameter Strip Length Terminal Series No. Terminal Order No. AWG mm mm In. mm In. 46235-0001 46235-0002 46235 20-24 0.50-0.20 1.30-1.85 .051-.073 2.54-2.92 .100-.115 46235-5001 46235-5002 DEFINITION OF TERMS BEND UP BELL MOUTH BRUSH SEAM INSULATION CRIMP ROLLING TWISTING STRIP BEND LENGTH DOWN CONDUCTOR CUT-OFF TAB CRIMP COND.CRIMP HEIGHT The above terminal drawing is a generic terminal representation. It is not an image of a terminal listed in the scope. Doc No: ATS-639101400 Release Date: 02-25-08 UNCONTROLLED COPY Page 1 of 6 Revision: B Revision Date: 09-22-10 T2 Terminator for Low Force Micro-Fit 3.0 Crimp Terminal CRIMP SPECIFICATION Bell mouth Cut-off Tab Maximum Conductor Brush Terminal Series No. mm In. mm In. mm In. 46235 0.05-0.40 .002-.016 0.25 .010 0.20-0.80 .008-.031 Punch Width (Ref) Seam Bend up Bend down Twist Roll Terminal Series No. Conductor Insulation Seam shall not be open And no wire allowed out Degree Degree mm In. mm In. 46235 3 3 4 8 1.20 .047 1.90 .075 After crimping, the crimp profiles should measure the following: Conductor Pull Force Wire Size Terminal Series No. Crimp Height Crimp Width (Ref) Minimum 2 AWG mm mm In. mm In. N Lb. 20 0.50 0.76-0.81 .030-.032 1.25 .049 57.9 13.0 46235 22 0.35 0.71-0.76 .028-.030 1.25 .049 35.6 8.0 24 0.20 0.66-0.71 .026-.028 1.25 .049 22.3 5.0 Tool Qualification Notes: 1. Pull Force should be measured with no influence from the insulation crimp. 2. The above specifications are guidelines to an optimum crimp. Doc No: ATS-639101400 Release Date: 02-25-08 UNCONTROLLED COPY Page 2 of 6 Revision: B Revision Date: 09-22-10