63911-2870 Molex

T2 Terminator for Sabre Flat Blade Crimp Terminal T2 Terminator Tooling Specification Sheet Part No. 63911-2800 FEATURES It is ideally suited for mid-volume bench operations This terminator can be installed in the TM42 and the TM40 press or Base Unit adapter for 3BF press Quick punch removal with the push of a button for fast and easy tooling change Track adjustment capabilities in the T2 Terminators for improved control of the bell mouth size and cutoff tab length T2 Terminator has standardized tooling with the Molex FineAdjust Applicator which will reduce your inventory requirements SCOPE Products: Sabre Flat Blade Crimp Terminal-18-20 AWG, UL1056 and SPT-3 wires. Wire Size Strip Length *Insulation Diameter Terminal Series No. Terminal Order No. AWG mm mm In. mm In. 43374 43374-3001 18-20 0.80-0.50 3.98-4.57 .157-.180 3.96-5.54 .156-.218 43375 43375-3001 18-20 0.80-0.50 3.98-4.57 .157-.180 3.96-5.54 .156-.218 *Insulation crimp to meet IPC/WHMA-A-620 Class 2 compliance. Note: Terminal will accommodate the UL1056 and SPT-3 wires. For UL1015 wires use Terminator 63911-2700. SPT-3 wire is only available in 18 AWG. DEFINITION OF TERMS BEND UP BELL MOUTH BRUSH SEAM INSULATION CRIMP ROLLING TWISTING STRIP BEND LENGTH DOWN CONDUCTOR CUT-OFF TAB CRIMP COND.CRIMP HEIGHT The above terminal drawing is a generic terminal representation. It is not an image of a terminal listed in the scope. Doc No: ATS-639112800 Release Date: 07-15-09 UNCONTROLLED COPY Page 1 of 6 Revision: B Revision Date: 01-26-10 T2 Terminator for Sabre Flat Blade Crimp Terminal CRIMP SPECIFICATION Cut-off Tab Conductor Brush Bell mouth Terminal Series No. Maximum Maximum mm In. mm In. mm In. 43374 0.20-0.50 .008-.020 0.30 .012 0.76 .030 43375 Punch Width (Ref) Seam Bend up Bend down Twist Roll Terminal Series No. Conductor Insulation Degree (Max) Degree (Max) mm In mm In Seam shall not be open and no wire allowed out 43374 3 3 4 8 2.00 .079 4.80 .189 of the crimping area 43375 After crimping, the conductor profile should measure the following. Insulation Crimp Height Pull Force Wire Size Conductor Crimp Height Terminal Series No. (Ref) Minimum 2 AWG mm mm In. mm In. N Lb. 18 0.80 1.16-1.26 .046-.050 4.20 .165 89.0 20.00 43374 20 0.50 1.10-1.20 .043-.047 3.90 .154 57.9 13.00 18 0.80 1.16-1.26 .046-.050 4.20 .165 89.0 20.00 43375 20 0.50 1.10-1.20 .043-.047 3.90 .154 57.9 13.00 Note: SPT-3 wire is only available in 18 AWG. Pull Force should be measured with no influence from the insulation crimp. The above specifications are guidelines to an optimum crimp. Doc No: ATS-639112800 Release Date: 07-15-09 UNCONTROLLED COPY Page 2 of 6 Revision: B Revision Date: 01-26-10