63912-4770 Molex

T2 Terminator for 2.00mm (.079 ) Pitch Wire-to-Board Crimp Terminal T2 Terminator Tooling (Full Radius Application Tooling Insulation Crimp) Specification Sheet Order No. 63912-4700 FEATURES This terminator can be installed in the TM42 and the TM40 press or Base Unit adapter for 3BF press It is ideally suited for mid-volume bench operations Quick punch removal with the push of a button for fast and easy tooling change Track adjustment capabilities in the T2 Terminators for improved control of the bell mouth size and cutoff tab length T2 Terminator has standardized tooling with the Molex FineAdjust Applicator which will reduce your inventory requirements SCOPE Products: Standard .093 (2.63mm) Pin and Socket Crimp Terminal Wire Size Insulation Diameter Strip Length Terminal Order No. Terminal Series No. AWG mm mm In. mm In. 42477 02-09-1615 14 2.07 2.79-3.56 .110-.140 3.96-5.33 .156-.218 42478 02-09-2611 02-09-2612 14 2.07 2.79-3.56 .110-.140 3.96-5.33 .156-.218 For 16-18 AWG 2.36mm (.093) -3.20mm (.126) insulation diameter, use 63912-4600 Terminator. DEFINITION OF TERMS BEND UP ROLLING SEAM BELL BRUSH CONDUCTOR MOUTH CRIMP INSULATION CRIMP TWISTING STRIP LENGTH BEND DOWN CUT-OFF TAB CRIMP HEIGHT The above terminal drawing is a generic terminal representation. It is not an image of a terminal listed in the scope. Doc No: ATS-639124700 Release Date: 04-29-11 UNCONTROLLED COPY Page 1 of 6 Revision: A Revision Date: 04-29-11 T2 Terminator for 2.00mm (.079 ) Pitch Wire-to-Board Crimp Terminal CRIMP SPECIFICATION Bell mouth Cut-off Tab Maximum Conductor Brush Terminal Series No. mm In. mm In. mm In. 42477 0.25-0.58 .010-.023 0.25 .010 0.13-0.55 .005-.022 42478 0.25-0.58 .010-.023 0.25 .010 0.13-0.55 .005-.022 Punch Width (Ref) Seam Bend up Bend down Twist Roll Terminal Series No. Conductor Insulation Degree Degree mm In mm In Seam shall not be open and no wire allowed out 42477 3 3 4 8 2.30 .090 3.60 .141 of the crimping area 42478 3 3 4 8 2.30 .090 3.60 .141 After crimping, the conductor profile should measure the following. Wire Size Conductor Crimp Height Pull Force Minimum Terminal Series No. 2 AWG mm mm In. N Lb. 42477 14 2.07 1.91-1.80 .075-.071 222.4 50.00 42478 14 2.07 1.91-1.80 .075-.071 222.4 50.00 Pull Force should be measured with no influence from the insulation crimp. The above specifications are guidelines to an optimum crimp. Doc No: ATS-639124700 Release Date: 04-29-11 UNCONTROLLED COPY Page 2 of 6 Revision: A Revision Date: 04-29-11