63850-6070 Molex

T2 Terminator 2.50mm (.098 ) Pitch Splash Proof Crimp Terminal T2 Terminator Tooling Specification Sheet Part No. 63850-6000 FEATURES It is ideally suited for mid-volume bench operations This terminator can be installed in the TM42 and the TM40 press or Base Unit adapter for 3BF press Quick punch removal with the push of a button for fast and easy tooling change Track adjustment capabilities in the T2 Terminators for improved control of the bell mouth size and cutoff tab length T2 Terminator has standardized tooling with the Molex FineAdjust Applicator which will reduce your inventory requirements SCOPE Products: 2.50mm (.098 ) Pitch Splash Proof Crimp Terminal, 20-22 AWG. Wire Size Insulation Diameter Strip Length Terminal Series No. Terminal Order No. AWG mm mm In. mm In. 50038 50038-8000 20-22 0.50-0.35 1.50-1.90 .059-075 2.00-2.50 .078-.098 50039 50039-8000 20-22 0.50-0.35 1.50-1.90 .059-075 2.00-2.50 .078-.098 DEFINITION OF TERMS BEND UP ROLLING SEAM BELL CONDUCTOR BRUSH MOUTH CRIMP INSULATION CRIMP TWISTING STRIP LENGTH BEND DOWN CUT-OFF CRIMP HEIGHT TAB The above terminal drawing is a generic terminal representation. It is not an image of a terminal listed in the scope. Doc No. ATS-638506000 Release Date: 09-22-06 UNCONTROLLED COPY Page 1 of 6 Revision: C Revision Date: 01-03-07 T2 Terminator 2.50mm (.098 ) Pitch Splash Proof Crimp Terminal CRIMP SPECIFICATION Bell mouth Cut-off Tab Max. Conductor Brush Terminal Series No. mm In. mm In. mm In. 50038 0.00-0.30 .000-.012 0.30 .012 0.10-0.90 .004-.035 50039 0.00-0.30 .000-.012 0.30 .012 0.10-0.90 .004-.035 Punch Width mm (Ref) Seam Bend up Bend down Twist Roll Terminal Series No. Conductor Insulation Seam shall not be open Degree (Max) Degree (Max) mm In mm In and no wire allowed out 50038 2 0 3 10 1.40 .055 1.80 .070 of the crimping area 50039 2 0 3 10 1.40 .055 1.80 .070 After crimping, the conductor profile should measure the following. Wire Size Conductor Crimp Height Pull Force Min. Terminal Order No. 2 AWG mm mm In. N Lb. 20 0.50 0.96-1.06 .038-.042 53.3 12.0 50038-8000 22 0.35 0.94-0.99 .037-.039 48.9 11.0 20 0.50 0.96-1.06 .038-.042 53.3 12.0 50039-8000 22 0.35 0.94-0.99 .037-.039 48.9 11.0 Pull Force should be measured with no influence from the insulation crimp. The above specifications are guidelines to an optimum crimp. Doc No. ATS-638506000 Release Date: 09-22-06 UNCONTROLLED COPY Page 2 of 6 Revision: C Revision Date: 01-03-07