63851-7170 Molex

T2 Terminator for 2.5 Mini Splash Proof Crimp Terminal T2 Terminator Tooling Application Tooling Specification Sheet Order No. 63851-7100 FEATURES This terminator can be installed in the TM42 and the TM40 press or Base Unit adapter for 3BF press It is ideally suited for mid-volume bench operations Quick punch removal with the push of a button for fast and easy tooling change Track adjustment capabilities in the T2 Terminators for improved control of the bell mouth size and cutoff tab length T2 Terminator has standardized tooling with the Molex FineAdjust Applicator which will reduce your inventory requirements SCOPE Products: 2.5 Mini Splash Proof Wire-to-Wire Crimp Terminal 20-22 AWG. Terminal Terminal Wire Size Insulation Diameter Strip Length Series No. Order No. AWG mm mm In. mm In. 22 --- AVSS-0.3 CAVS-0.3 50147 50147-8000 CAVUS-0.3 1.40-1.90 .075-.055 2.00-2.50 .078-.098 50148 50148-8000 20 --- AVSS-0.5 CAVS-0.5 CAVUS-0.5 DEFINITION OF TERMS BEND UP ROLLING SEAM BELL CONDUCTOR BRUSH MOUTH CRIMP INSULATION CRIMP TWISTING STRIP LENGTH BEND DOWN CUT-OFF CRIMP HEIGHT TAB The above terminal drawing is a generic terminal representation. It is not an image of any terminal listed in the scope. Doc No: ATS-638517100 Release Date: 02-16-00 UNCONTROLLED COPY Page 1 of 6 Revision: B Revision Date: 03-02-09 T2 Terminator for 2.5 Mini Splash Proof Crimp Terminal CRIMP SPECIFICATION Bell mouth Cut-off Tab Maximum Conductor Brush Terminal Series No. mm In. mm In. mm In. 50147 0.00-0.30 .000-.012 0.00-0.30 .000-.012 0.10-0.90 .004-.035 50148 Punch Width (Ref) Bend up Bend down Twist Roll Seam Terminal Series No. Conductor Insulation Seam shall not be Degree Degree mm In mm In open and no wire allowed 50147 out of the crimping area 2 3 3 10 1.40 .055 1.60 .063 50148 After crimping, the crimp profiles should measure the following: Conductor Insulation Pull Force Wire Size Terminal Crimp Height Crimp Height Minimum Series No. Maximum 2 AWG mm mm In. mm In. N Lb. 22 --- 0.94-0.99 .037-.039 1.70 .067 49.0 11.0 AVSS-0.3 0.94-0.99 037-.039 1.70 .067 49.0 11.0 CAVS-0.3 50147 20 --- 0.96-1.06 .038-.042 1.80 .071 53.9 12.1 50148 AVSS-0.5 0.96-1.06 .038-.042 1.80 .071 53.9 12.1 CAVS-0.5 CAVUS-0.3 0.94-0.99 037-.039 1.55 .061 49.0 11.0 CAVUS-0.5 0.96-1.06 .038-.042 1.80 .067 53.9 12.1 Tool Qualification Notes: 1. Pull Force should be measured with no influence from the insulation crimp. 2. The above specifications are guidelines to an optimum crimp. Doc No: ATS-638517100 Release Date: 02-16-00 UNCONTROLLED COPY Page 2 of 6 Revision: B Revision Date: 03-02-09